Whale Supersub Bilge Pumps – 31.5l/m / 502gph Open Flow 12 Volt

Supersub Family- Narrow, low profile bilge pump fits deep down in small/ awkward bilge spaces where other pumps won’t fit.

•Low narrow design for confined bilge spaces only 54mm

•Easy installation – outlet and pump body rotate to suit your installation – vertical or horizontal

•High performance – Flow up to 1100 US gals per hour

•Efficient operation – Very low power consumption

•Easy to clean- snap fit assembly

•Low profile strainer – Leaves the bilge almost dry

•Removable strainer for easy cleaning

•131658/131660 features 25/28mm stepped hose connector

•Non Return Valve

Outlet Dia.: 19mm 

Power: 12v / 2.6amps 

Mount Screws Gauge: 4mm r/h

Whale Supersub Datasheet

Whale Supersub Installation Instructions  

N.B Output specifications are in US gallons per hour open flow. As with all submersible electric’s, attention is needed during installation to ensure that wiring connections remain above water level. All Whale Supersub bilge pump models, Supersub 500, 650 and 1100 and Supersub Smart 650 and 1100 are uniquely designed, specifically for fast and efficient removal of bilge water from leisure craft. The Supersub range fits into narrow and low spaces that other bilge pumps cannot reach. SS5012, SS5022, SS1012 AND SS1024 ARE NOT AUTOMATIC PUMPS. Supersub Smart 650 and 1100 are automatic. The pump will sense the presence of water and will switch on the pump, turning it off again when the water level has dropped. The switching is solid state hence there are no moving parts. The Supersub Smart models allow waves of water to pass over, without turning the pump on every time, as it has a built in time delay.