The Ark XO Series Jockey Wheel Replacement Handle steps in when the original crank has gone missing or worn out, so you can still raise and lower your drawbar without stuffing around at camp or in the driveway. The soft grip section sits comfortably in the hand while you wind the XO wheel on models like the ORJW750, ORJW500, ORJW350, ORJW1SU and ORJW2SU, keeping control as the weight comes on or off the jockey wheel. The handle arm uses rust resistant metal that holds up well to road spray, mud and the odd salty carpark, which suits typical Aussie towing from the bush to the beach. A magnetic feature keeps the handle snug against the XO assembly when you are rolling, cutting down movement and knock. If your old handle is bent, lost or chewed out, this replacement is a smart buy that gets the gear working again without changing the whole jockey wheel.

• Genuine Ark XO Series replacement handle
• Soft handle grip for comfortable cranking
• Magnetic handle feature to hold position
• Rust resistant construction for outdoor use
• Suits Ark XO ORJW750 jockey wheel
• Suits Ark XO ORJW500 jockey wheel
• Suits Ark XO ORJW350 jockey wheel
• Suits Ark XO ORJW1SU and ORJW2SU
• Simple direct replacement for damaged handles
• Suitable for caravan, camper and trailer jockey wheels using listed Ark XO models

Q: Will this handle fit non-Ark jockey wheels?

No, this handle is made for Ark XO jockey wheel models only. The drive end and offset are matched to the XO range, so it will not line up correctly on most non-Ark units. For other brands, you will need a handle specified by that manufacturer. Using the wrong handle can round out drive points or slip under load.

Q: Is any hardware included with the replacement handle?

No, this listing is for the Ark XO Series jockey wheel replacement handle only. The handle is intended to reuse the existing mounting and drive hardware already on your XO jockey wheel. If any pins or bolts are damaged or missing, they will need to be sourced separately. Check your current setup before ordering.

Q: Can the magnetic feature hold the handle while driving on corrugated roads?

Yes, the handle includes a magnetic feature to help hold it against the XO assembly during travel. The magnet is intended to reduce movement and rattle when the trailer is in motion. You should still make sure the handle is parked correctly before towing. Regularly check the jockey wheel and handle during long trips.

Q: Does the rust resistant finish mean it can be left outside all year?

The handle uses rust resistant materials to cope with normal outdoor and on-road use. Long term exposure to salt, fertilisers or harsh chemicals can still mark the surface over time. Rinsing with fresh water after beach trips and storing the trailer on firm ground will help extend the life of the handle. Basic care keeps the grip clean and comfortable.

Suitable as a replacement handle for Ark XO Jockey Wheel models ORJW750, ORJW500, ORJW350, ORJW1SU and ORJW2SU.