The Coast to Coast PLASTIC BSP Elbow 3/4 inch keeps your tank plumbing tight against lockers and frames with a simple 90 degree turn. The 3/4 inch BSP thread lines up with common caravan and RV water tank fittings so you can route lines around drawers and chassis rails without crushing hose. The compact plastic body suits small service hatches where straight connectors chew up too much space. This elbow runs a 3/4 inch bore through a hard plastic body so flow from tanks to taps stays steady across normal caravan setups. The BSP thread pitch matches standard plumbing gear so it drops into existing pipe runs that already use 3/4 inch fittings. The plastic construction avoids rust near damp tank bays and underfloor cavities. The light weight also helps keep overall trailer weight in check which is a smart buy for longer touring loads.

• Brand: Coast to Coast
• Model: 800-01700 plastic BSP elbow
• Standard 3/4" BSP threaded connections
• Right angle elbow for direction change
• Suitable for caravan and RV plumbing
• Commonly used on water tanks and accessories
• Plastic construction helps resist corrosion
• Lightweight fitting suits weight-conscious setups
• Hex sections allow tightening with a spanner
• Handy spare for on-road plumbing repairs

Q: Can this 3/4" plastic BSP elbow be used on both inlet and outlet lines of a caravan water tank?

Yes, it can be used on either inlet or outlet lines where a 3/4" BSP thread is present. The elbow simply changes the direction of flow through 90 degrees without restricting the standard 3/4" bore. Many setups run one on the tank outlet to clear cross members. Others use them on fill lines that need to turn towards a side wall fitting.

Q: Is this elbow suitable for fresh water use in caravans and RVs?

Yes, this elbow is suitable for typical fresh water plumbing layouts in caravans and RVs. The plastic construction is commonly used in non-pressurised or low-pressure tank connections. It suits the kind of hose runs that feed sinks and showers from onboard tanks. Always pair it with compatible seals and thread tape where needed.

Q: Does the Coast to Coast 3/4" BSP elbow require any special tools for installation?

No, it installs with standard hand tools that fit caravan plumbing fittings. Most users fit it by hand and finish tightening with a suitable spanner on the hex section. Use thread tape on male threads where appropriate to help seal the joint. Avoid overtightening to protect both the elbow and the tank outlet.

Q: Can I keep a spare 3/4" BSP elbow in my caravan for roadside repairs?

Yes, many travellers keep a spare 3/4" BSP elbow in their plumbing kit. The compact plastic body takes up very little room in a toolbox. A spare fitting can get a leaking or cracked connection working again on the road. It is a simple bit of insurance for longer trips away from major towns.

• Suits 3/4" BSP threaded plumbing systems
• Compatible with caravan and RV water tanks and accessories using 3/4" BSP fittings
• Install into matching 3/4" BSP female or male connectors as required by the setup