The Relaxn Stainless Steel Slim Straight Rod Holder gives you a straight drop tube at 215mm so a single rod sits steady in the gunwale while you watch the sounder. The slim body leaves room on narrow decks where space between cleats might only be 70mm. The square flange with four mounting points spreads the load when a hooked fish leans hard on the rail.

The holder runs a full 215mm of stainless tube so the butt stays buried and the reel sits clear of wash on low freeboard hulls. Stainless steel stands up well to saltwater spray and run-off on Aussie estuaries and bays. The smooth finish wipes clean after a day with bait and burley on the deck. Bolt a few of these in line and you have simple, reliable storage for trolling and bait soaking sessions.

• Relaxn stainless steel slim straight rod holder
• Marine grade stainless steel construction
• Overall holder height: 215mm
• Slim tube ideal for narrow gunwales
• Straight drop design for vertical rod storage
• Square flange with four mounting holes
• Suits deck or gunwale flush mounting
• Corrosion resistant finish for saltwater use
• Helps keep rods secure while trolling or drifting
• Simple, low profile rod storage solution

Q: Can this rod holder be mounted in aluminium or fibreglass decks?

Yes, it can be mounted in both aluminium and fibreglass decks. You just need to match the fasteners and sealant to the deck material. On aluminium, use stainless or suitable marine-grade bolts with an isolating sealant. On fibreglass, use wide washers or backing plates to spread loads and reduce stress cracking.

Q: How many rod holders like this should I fit on a small fishing boat?

Most small fishing boats use at least two rod holders. Two holders let you run a spread of lures or baits without crowding the transom. Extra holders can be added along the gunwales for storage when under way. The exact number comes down to available space and how many rods you usually carry.

Q: Does the stainless finish require any special maintenance after saltwater trips?

Regular rinsing with fresh water is usually enough. A quick wash after each saltwater run helps prevent surface tea staining on stainless. Mild boat wash can be used for stubborn grime. Occasional use of a stainless cleaner keeps the finish looking tidy over time.

Q: Can this holder be used for trolling at higher speeds?

Yes, when mounted correctly with suitable backing and fasteners, it can be used for trolling. The 215mm depth keeps the rod butt seated under load. Make sure the mounting area is strong and free of rot or corrosion. Check bolts and sealant occasionally as part of your normal boat inspection.

• Suited to mounting into flat horizontal marine surfaces where a straight rod holder is required
• Requires suitable fasteners through the four flange holes and appropriate sealant for the mounting surface
• Fits standard fishing rods sized to suit a slim straight stainless tube holder
• Installation time depends on access to the mounting area and the structure thickness