The Furrion AC Underbunk Ducting Pipe runs a 60mm air path from your caravan AC to low vents under the bunks. The 10m roll means you can cut sections to suit two or three beds off one length. The flexible duct shape slips through gaps as low as 80–100mm behind cupboards and drawers. The size lines up with Furrion style outlets so you can hook into existing 60mm collars without drama.

The corrugated wall is light but built tough enough for the fan pressures you see on caravan units around 100Pa. The 10m continuous run cuts down how many taped joins you need to chase later. The 60mm bore balances airflow and space when you are threading it past tanks or wiring looms. The roll suits standard bunk runs in vans up to about 20ft where the AC sits forward of the sleeping area.

• Furrion AC underbunk ducting pipe for caravans and RVs
• 60mm internal diameter suits matching Furrion vents
• Supplied in a continuous 10m roll
• Flexible corrugated construction for tight routing
• Ideal for running air to bunk and floor outlets
• Compatible with 60mm collars, Y-pieces and vents
• Suits built-in caravan and RV air conditioners
• Helps reduce air leaks by minimising joins
• Lightweight design fits shallow furniture voids
• Neutral colour blends into service spaces

Q: Can I cut the 10m ducting roll into shorter lengths?

Yes, the 10m ducting roll can be cut to suit your layout. Most installers trim it into several runs for separate bunks or outlets. Use a sharp knife or fine-tooth saw for a clean edge. After cutting, secure each end to the vent or collar with clamps or suitable tape so you do not lose airflow through leaks.

Q: Is this ducting only for underbunk use in caravans?

The duct is intended for underbunk and under-furniture air runs in caravans and RVs that use compatible Furrion air conditioners. You can route it under seats or through lower cupboards if they share the same 60mm fittings. The flexible wall helps it pass around framing and tanks. Always check there is enough clearance and no sharp edges that could damage the hose.

Q: Do I need special fittings to attach the ducting to vents?

You will need 60mm compatible collars or vents to attach this ducting. Most Furrion style outlets and Y-pieces accept a 60mm hose. Push the duct over the spigot, then lock it with a clamp or strong HVAC tape. A firm mechanical connection helps maintain airflow and reduces noise from leaks when the fan runs.

Q: Can this ducting handle the heat from reverse cycle heating modes?

The duct is built for typical caravan and RV AC airflow temperature ranges. Reverse cycle systems usually move air that is warm rather than extremely hot. As long as the hose is used within the air conditioner manufacturer’s normal operating limits, it will suit standard bunk and floor-level outlets. Avoid running it against hot exhausts, flues, or cooking appliances.

• Suits air distribution runs for compatible Furrion caravan and RV built-in air conditioners
• 60mm diameter duct interfaces with matching 60mm collars and vents
• Intended for underbunk or under-furniture routing where space is limited
• Duct can be cut to length to suit multiple outlets across a 10m run
• Secure connection typically requires compatible clamps or collars at each join