The Sam Allen Plastic Pealess Whistle sits on your PFD1 or safety kit and gives a loud blast when you need attention fast on the water. The body comes in a bright orange finish so you can spot it in a tangle of straps or gear on a moving deck. The whistle stays compact at about 72mm long and 18mm wide so it never feels bulky against a jacket or throw bag.

The whistle uses plastic construction and a pealess design so there is no loose ball to jam up after a few soakings. The underside clip locks onto common PFD1 webbing and other safety straps so you can keep it in the same spot every trip. A small lanyard hole lets you run cord or cable ties if that suits your setup better. The whole kit works as straightforward safety gear for standard marine use.

• Plastic pealess safety whistle for marine use
• Required accessory for many PFD1 lifejackets
• Compact body length of 72mm
• Slim 18mm width suits jacket straps
• High-visibility orange plastic construction
• Integrated clip for attaching to webbing
• Lanyard hole for cord or tether
• Pealess design with no moving ball
• Suits general safety kits and emergency bags
• Sam Allen part number 50584

Q: Does the whistle include a lanyard?

No, the whistle does not include a lanyard. The body features a dedicated lanyard hole so you can attach your own cord or fit it to an existing tether. This lets you match the cord length and material to your jacket or bag. Many boaties tie it straight to a PFD buckle or zip pull.

Q: Can this whistle be clipped straight onto a PFD1 jacket?

Yes, the whistle has an integrated attachment clip that suits typical PFD1 webbing. You slide the clip over a strap or loop where you want the whistle to sit. Once fitted, it stays within reach on the front of the jacket. This setup keeps the whistle consistent across different users and trips.

Q: Is this whistle suitable for general marine safety kits?

Yes, the whistle suits most general marine safety kits that require an audible signal device. The compact 72mm length means it fits easily in grab bags or small dry boxes. The bright orange plastic stands out among other gear. The pealess design keeps the sound output consistent when wet or splashed.

Q: What type of maintenance does this whistle need?

The whistle needs only occasional rinsing in fresh water after use. A quick rinse helps remove salt crystals and sand from the sound channels. Allow it to dry fully before stowing it in an enclosed compartment. Regular checks of the clip and lanyard point help ensure it stays ready for use.

• Suitable for use with PFD1 lifejackets where a whistle is required
• Fits to jackets or safety gear via built-in attachment clip
• Lanyard hole allows connection to cord or existing PFD loops
• General-purpose fit across many marine safety products that accept clip-on whistles