If your Fiamma F45 centre rafter has lost its wall clip this F45 Centre Rafter Bracket Van Side gets the gear working again without replacing the whole kit. The small U-shaped cradle holds the rafter end against the van wall so the curved roof bar can tackle wind flap on spans up to around 3–4 metres. The footprint is compact so you can mount it near doors or windows where space is tight.

The bracket body is moulded plastic with enough wall thickness to handle weekend-after-weekend use under a loaded rafter. A single metal screw passes through the centre boss to bite into backing timber or structural sheet on the van. The internal shape lines up with standard F45 rafter tube profiles so the bar snaps in and out cleanly. For anyone running Fiamma F45 gear this is a smart buy to keep the awning setup sorted.

• Genuine Fiamma centre rafter bracket for F45 awnings
• Van-side clip to hold the curved roof rafter end
• Ideal replacement spare for existing F45 rafter kits
• Compact U-shaped cradle suits tight mounting spaces
• Moulded plastic body with integrated screw boss
• Supplied with a central metal fixing screw
• Suits installation on caravan or van side wall
• Helps support rafter across longer awning spans
• Simple clip-in design for quick rafter attachment
• SKU 200-05518 with UPC 303981

Q: Is this bracket supplied as a single piece or a pair?

This centre rafter bracket is supplied as a single van-side bracket. You would normally use one bracket for the centre rafter location on the wall. If you want brackets at more than one position you would need to order additional units. The rafter itself and any awning hardware are not included.

Q: Does this include the fixing screw shown in the picture?

Yes this centre rafter bracket is supplied with the screw shown installed through the middle. The screw suits many caravan or van wall constructions that accept a standard metal fixing. You may choose different hardware if your wall construction requires it. Always use suitable sealant and backing where required.

Q: Will this bracket fit any Fiamma F45 centre rafter?

This bracket is intended for Fiamma F45 centre rafter styles that use a clip-in van-side cradle. The internal profile matches the common F45 curved roof rafter end fitting. If your existing rafter end looks different you should compare visually before ordering. When matched it gives a snug support point for the rafter.

Q: Can I reposition the bracket to change the rafter angle?

Yes the bracket position on the van wall determines where the rafter contacts the awning. You can mount it higher or lower within the limits of your wall framing. Pre-marking the spot with the rafter in place helps set the correct angle. Always ensure the mounting point is strong enough to take the rafter load.

This bracket fits to the van or caravan wall to receive the centre rafter used with Fiamma F45 awnings. It is intended as a replacement spare for existing F45 curved roof rafter setups that use a van-side clip bracket. Installation requires suitable mounting hardware and sealant to match the vehicle wall construction. Positioning should align with the mating end on the rafter bar and existing awning hardware.