The Ark Chrome Clip-On Tow Ball Cover is straightforward gear for covering greasy tow balls on everyday rigs. It clips over standard 50 mm and 47.63 mm (1 7/8") balls so you can lean into the tub or grab gear from the back without brushing against the hitch. A built-in spring clip keeps it seated on the tow ball as you head from work to the campsite or the boat ramp.

The shell runs a chrome outer finish over a solid cover body with Ark part code PCC50D. The internal profile is shaped around the regular tow ball head so it seats cleanly on both 50 mm and 47.63 mm sizes. There are no tools or extra brackets in the setup which keeps the kit simple and reliable for weekend after weekend on Aussie roads and in coastal air.

• Ark chrome clip-on tow ball cover
• Suits 50mm and 47.63mm (1 7/8") tow balls
• Chrome finish matches common tow hardware
• Internal spring clip secures cover to ball
• Helps protect clothing from tow ball grease
• Simple one-piece clip-on design
• Suitable for general vehicle towing setups
• Identified by Ark part code PCC50D
• Intended for use when tow ball is not towing
• Compact accessory for caravan and trailer owners

Q: Will this tow ball cover stay on while driving?

Yes, the cover is held on by an internal spring clip. The spring clip grips the tow ball under normal on-road vibration. It is intended to stay in place between towing jobs. Always check it is seated properly before heading off and remove it before you connect a trailer.

Q: Do I need tools to fit the Ark chrome clip-on tow ball cover?

No, this cover is a clip-on design. You position it over the tow ball and press down so the internal spring clip locks onto the ball. This keeps the setup simple around the hitch area. There are no bolts, screws or extra brackets involved.

Q: What tow ball sizes does this cover fit?

This cover suits 50mm and 47.63mm (1 7/8") tow balls. These are the common sizes found on many Australian towbars. If your existing tow ball is either of these diameters it should be compatible. Always confirm the stamped size on the tow ball head before ordering.

Q: Can I tow a trailer with the cover still fitted?

No, the cover must be removed before towing. The cover is made to protect clothes and reduce grease contact when the tow ball is not in use. Leaving it on while coupled could interfere with the trailer coupling. Take the cover off, stow it, then refit it after the trailer is disconnected.

• Fits standard 50mm tow balls
• Fits 47.63mm (1 7/8") tow balls
• Application: General towing setups on vehicles with compatible tow balls
• Installation: Clips directly over existing tow ball using internal spring clip