The Aussie Traveller Anti-Flap Kit Center Insert White steps in when the original middle bar on your Anti Flap Kit cops damage over its 450mm length. The insert spans that same 450mm section so your awning edge stays firm again instead of flapping around in gusts. The gear works with the existing Anti Flap Kit fittings so you keep the rest of your setup bolted on and ready to tackle windy sites. This centre insert runs to roughly 450mm and follows the original Aussie Traveller Anti Flap Kit profile so it slots straight back into the system. The white finish lines up with standard caravan awning hardware so your kit looks neat along the awning arm. The solid section helps carry the clamping load across that 450mm strip which is what keeps the fabric steady when you get out there on exposed coastal or inland sites.

• Replacement centre insert for Aussie Traveller Anti-Flap Kit
• Approximate length of 450mm
• Restores clamping support along awning edge
• Suits existing Aussie Traveller Anti-Flap Kit systems
• White finish to match standard awning hardware
• Rigid profile helps reduce awning fabric flap
• Intended as a spare or replacement component
• Fits into original Anti-Flap Kit channels
• Ideal for caravans and RVs using AFK setups

Q: Is this the full Aussie Traveller Anti-Flap Kit or just one part?

This is just the centre insert section. It replaces the middle support piece in an existing Aussie Traveller Anti Flap Kit, rather than the full setup. You will still need your original Anti Flap Kit arms and clamps for it to work properly. Treat it as a spare part to refresh a damaged or lost centre bar.

Q: Can I use this centre insert on other brands of anti-flap gear?

It is intended for Aussie Traveller Anti Flap Kits only. Other brands use different profiles and fittings, so this 450mm insert may not seat correctly in their channels. For best results, match spare parts to the same brand as your existing gear. That way the clamping surfaces line up as designed.

Q: Do I need extra bolts or brackets to fit this insert?

No extra fittings are listed for this insert. It is made to work with the fasteners and clamps already supplied with your Aussie Traveller Anti Flap Kit. Just remove the old centre section, slide this one into place, and refit it to the original hardware. Always check everything is tensioned properly after replacement.

Q: Will the white colour suit older Anti-Flap Kits on my caravan?

The insert is supplied in white to match Aussie Traveller Anti Flap Kit hardware. Many caravan awning systems use white or light-coloured fittings, so this part generally blends in well. Colour match does not affect performance but it keeps your setup looking tidy. If your existing gear is badly discoloured, this insert may appear brighter beside it.

• Suits Aussie Traveller Anti-Flap Kit systems on compatible caravan and RV awnings
• Approximate insert length: 450mm
• Install by sliding into the existing Anti-Flap Kit channel and securing with the kit hardware
• No additional brackets or adaptors specified
• Intended as a direct replacement centre insert only