The Aussie Traveller Knob & T-Nut steps in when the original awning fastener goes missing, locking straight into Sunburst awnings, Anti-Flap Kits and Curved Roof Rafters for normal touring setups. The knurled knob gives plenty of grip to tension side walls or rafters by hand, so you can keep the shade tight and stop that annoying flap when the afternoon breeze kicks across camp.

The T-nut is stainless steel, so it handles road spray and salty air on coastal runs without seizing up or rust streaking your awning hardware. The knob uses solid plastic that shrugs off knocks in the front boot and does not feel icy when the temperature drops. Put this small bit of kit in the spares box and you have a smart buy that keeps your existing Aussie Traveller gear working trip after trip.

• Replacement knurled knob and T-nut set
• Suits Aussie Traveller Sunburst awnings
• Compatible with Anti-Flap Kits
• Compatible with Curved Roof Rafters
• T-nut made from stainless steel
• Knob manufactured from durable plastic
• Hand-tightened design for quick adjustment
• Ideal spare part for caravan awning hardware
• Helps maintain tension on awning panels
• Compact size for easy storage in spares box

Q: Is this knob and T-nut sold as a single set or in pairs?

This knob and T-nut are supplied as a single set. That means you receive one plastic knurled knob and one stainless steel T-nut. If you need to replace multiple fastening points on an Anti-Flap Kit or Curved Roof Rafter you will need to order additional sets. Keeping a couple of spare sets in the van helps avoid issues if one goes missing at camp.

Q: Will this set fit non–Aussie Traveller awnings or hardware?

This set is made to suit Aussie Traveller Sunburst awnings, Anti-Flap Kits and Curved Roof Rafters. Thread size and T-slot profile are matched to that specific gear. Other brands may use different channels or threads so fit is not guaranteed. For non–Aussie Traveller setups it is best to use hardware supplied or specified by that manufacturer.

Q: Do I need tools to install or remove this knob and T-nut?

No tools are required for normal use. The stainless steel T-nut slides into the appropriate channel and the plastic knurled knob is tightened or loosened by hand. This makes it straightforward to adjust wall tension or roof rafters as wind conditions change. Hand tightening also reduces the risk of over-tightening and damaging the awning rail.

Q: Can I leave the knob and T-nut in place while travelling?

Yes it can stay fitted to the awning hardware while you are on the road. Many caravan owners leave the sets assembled on Anti-Flap Kits or Curved Roof Rafters so setup at camp is quicker. Just make sure the awning and accessories are properly stowed as per the manufacturer instructions before towing. Regularly check the hardware for wear or damage during routine gear inspections.

This replacement knob and T-nut suits Aussie Traveller Sunburst Awnings Anti-Flap Kits and Curved Roof Rafters. The kit fastens into the existing T-slot on compatible hardware. Installation uses the threaded stainless steel T-nut and hand-tightened plastic knurled knob. No vehicle-specific fitment applies as the parts attach directly to the Aussie Traveller awning accessories.