The Alko Hex Winder Handle at 800 mm gives you reach to tackle corner jacks without crawling too far under the van. The long shaft at roughly 80 cm means fewer bends at the knees when you wind up stabilisers after a night on uneven ground. The hex end suits Alko style corner jacks so the handle locks in firmly with each turn and keeps the jack movement controlled. The steel construction runs the full 800 mm to handle the twisting load common on gravel and corrugated sites. The offset bend sits high enough to clear drawbars and rails around 150 mm deep so your knuckles stay away from sharp steel. The handle grip section spans about 100 mm which gives enough room for a solid two-hand hold when the jack is under load. It is straightforward gear and a smart buy for regular touring.

• Hex style winder handle to suit corner jacks

• Overall handle length of 800 mm

• Provides extra leverage for raising and lowering jacks

• Long reach helps access jacks under the chassis

• Hex drive end matches Alko style hex sockets

• Steel construction suitable for caravan and RV use

• Offset bends keep hands clear of chassis rails

• Simple one-piece tool with integrated handle grip

• Compact enough to store in toolbox or front boot

Q: Does this Alko hex winder handle fit all corner jacks?

It fits corner jacks that use a compatible hex drive head. The handle is described as a hex style winder handle to suit corner jacks, so it is intended for jacks with a hex socket. Some jacks use different drive types like square or slotted ends. If your jack takes a hex-shaped winder, this handle is likely suitable. Always compare the existing winder head to confirm compatibility.

Q: What is the total length of the handle including the grip?

The total length is 800 mm including the handle. That measurement runs from the hex end right through to the outer end of the grip. The long length gives more leverage compared with shorter handles. It also helps reach jacks set further under the chassis. This makes it practical for many caravan and RV setups.

Q: Can this handle be used on both caravans and camper trailers?

Yes, as long as the corner jacks use a compatible hex drive. Many caravans, camper trailers, and RVs share similar corner jack designs. The key requirement is that the jack accepts a hex style winder head. If the hex size matches and the jack turns freely with a hex tool, this handle can be used. Always test fit carefully before applying heavy load.

Q: Is any extra hardware needed to use this winder handle?

No extra hardware is specified for use with this handle. The winder is a one-piece tool with the hex drive formed at the end of the shaft. You place the hex end onto the jack drive and start turning. There are no brackets, adaptors, or fasteners listed as required. Just store it in your toolbox or front boot when not in use.

• Suits corner jacks that accept a compatible hex style winder handle
• Suitable for caravans and RVs that use hex drive corner stabiliser jacks
• Check hex size and jack design on your existing setup before purchase
• No additional brackets or adapters are listed with this handle