The Aussie Traveller Anti-Flap Kit Spigot End keeps a standard Anti-Flap Kit working when the original spigot wears or bends. This little bit of gear slots into the Anti-Flap Kit arm and anchors into the awning hardware, so your clamp still holds the awning fabric steady in crosswinds. You reuse the existing Anti-Flap Kit screw, so swap-over is straightforward in the driveway or at camp before you roll out.

This replacement spigot end runs a solid metal pin and a compact moulded body that mates cleanly with the Anti-Flap Kit channel. The metal section takes the load at the awning connection point, while the body keeps everything aligned along the arm. It is sized specifically for standard Aussie Traveller Anti-Flap Kits and does not match Curved Roof Rafters. If your current pin is bent or loose, this is a smart buy to keep the setup going.

• Genuine Aussie Traveller Anti-Flap Kit spare part
• Replacement spigot end for existing Anti-Flap Kits
• Uses the original Anti-Flap Kit screw for installation
• Helps restore firm connection between kit and awning
• Compact moulded body nests inside kit extrusion
• Solid metal spigot pin interfaces with awning hardware
• Suitable only for standard Anti-Flap Kit setups
• Not suitable for Curved Roof Rafter systems
• Ideal when the original spigot is worn or bent
• Simple swap-over using basic hand tools

Q: Do I need any extra screws or brackets to fit this spigot end?

No, this spigot end is made to reuse the existing screw from your Anti-Flap Kit. That means you remove the old spigot, keep the original screw, and refit it through the new part. This keeps the clamp force the same as the rest of the kit. It also avoids mixing hardware that might not seat properly in the extrusion.

Q: Will this spigot end fit all Aussie Traveller Anti-Flap Kits?

This spigot end is suitable for standard Aussie Traveller Anti-Flap Kits only. It is shaped to match the common straight Anti-Flap Kit extrusion that clamps onto a roll-out awning. If your setup uses curved roof rafters or a different style of anti-flap arm, this part will not be the right shape. Always compare the old spigot to the new one before installation.

Q: Can I use this spigot end with Curved Roof Rafters on my awning?

No, this product is not suitable for Curved Roof Rafters. The spigot body and pin are made for the Anti-Flap Kit arm profile, not the rafter profile. Using it on a curved rafter could lead to poor engagement at the awning barrel. Stick with parts made specifically for your rafter system.

Q: Is this spigot end side-specific on the Anti-Flap Kit?

The spigot end is intended to replace the existing spigot on the relevant Anti-Flap Kit arm. In most setups you match the new part to the same location as the old one. Removing only one arm at a time helps you keep track of orientation. If unsure, lay the old and new parts side by side before fitting so the clamp still lines up with the awning.

• Fitment location: Spigot end of existing Aussie Traveller Anti-Flap Kit
• Installation note: Retain and reuse original Anti-Flap Kit screw when replacing this spigot end
• Compatibility note: Not suitable for use with Curved Roof Rafters