The Aussie Traveller Anti-Flap Kit Cam Handle w/ Spring replaces the original handle on an Anti-Flap Kit bar that runs along an awning edge on spans around 2.4 m to 6 m. The metal handle uses a short cam throw to clamp the anti-flap bar onto the awning fabric so the vinyl stays steadier when the wind picks up at camp. The included spring, washer and nut keep the handle loaded on the stud so it stays where you set it.

The handle is a compact metal casting about 90 mm long, giving good leverage without sticking too far past the anti-flap bar. The stainless spring sits around 20 mm long so it keeps tension on the cam without feeling too stiff. A flat washer and matching nut fit the factory stud on the Anti-Flap Kit bar, so you can bolt it straight on and get out there again without changing the rest of your setup.

• Replacement cam handle for Aussie Traveller Anti-Flap Kit
• Supplied as a complete assembly with handle, spring, washer and nut
• Spring manufactured from stainless steel for corrosion resistance
• Metal handle body provides solid clamping leverage on awning edge
• Suits caravan and RV rollout awnings using genuine Anti-Flap Kits
• Ideal for replacing damaged or worn cam handles on existing bars
• Compact handle profile helps clear nearby walls and frames
• Simple mechanical fitment using the original Anti-Flap Kit mounting stud
• Handy spare part to keep Anti-Flap Kit operational on long trips

Q: Does this cam handle fit all Aussie Traveller Anti-Flap Kits?

This cam handle is intended for use with Aussie Traveller Anti-Flap Kit bars. The handle, spring, washer and nut match the standard bar stud used on genuine Aussie Traveller Anti-Flap Kits. If your bar is a different brand, the stud size or shape may differ and the handle may not seat correctly. Check that your existing handle matches the shape and mounting style before ordering.

Q: Is any extra hardware needed to install this handle kit?

No extra hardware is required beyond what is included. The kit supplies the cam handle, stainless steel spring, washer and nut which together mount on the existing Anti-Flap Kit stud. You remove the old handle and hardware, slide on the new spring and handle, then refit the washer and nut. Standard hand tools such as a small spanner are normally enough for the job.

Q: Can I carry this as a spare in case the original handle fails on a trip?

Yes, this handle kit works well as a spare for an Aussie Traveller Anti-Flap Kit. The loose components pack down small in a parts box or drawer in the van. Having a spare handle on hand means you can keep the Anti-Flap Kit working if the original handle gets bent or lost. That helps you keep the awning clamped properly in windy conditions away from town.

Q: Is the spring in this kit made from stainless steel?

Yes, the spring supplied in this kit is stainless steel. Stainless spring wire handles moisture, road grime and coastal air better than plain steel. That reduces the chance of rust that could cause the spring to weaken or seize on the stud. It also means you can rinse the Anti-Flap Kit and awning hardware without worrying about rapid corrosion.

Suitable as a replacement cam handle assembly for Aussie Traveller Anti-Flap Kit awning systems used on caravans and RVs. Installs onto the Anti-Flap Kit bar where the original cam handle is mounted. Reuses the existing Anti-Flap Kit body and clamp components.