This Camec Round Door Stop & Screw at 75mm gives your caravan or RV door a simple fixed stopping point so it does not smack straight into a wall panel. The round head sits around 20 mm across so the contact is spread instead of biting into one small spot on the door skin. One screw at roughly 70mm length holds the stop in place on timber or composite framing.

The stop body runs a straight 75mm length so you can line it up with common door swing clearances of 90° to about 120° without extra brackets. The included screw suits standard caravan hardware holes between about 4 mm and 6 mm. That means you can swap it in where an older stop has worn down to under 60mm and the door now hits trim or furniture. Simple dimensions make this a smart buy for spares in the van.

• Camec round door stop and screw kit
• 75mm overall length for door spacing
• Round head spreads contact on door edge
• Single screw mounting for simple installation
• Suits caravan and RV door applications
• Compact size ideal for tight interior spaces
• Helps prevent door damage to walls and furniture
• Can replace existing 75mm Camec door stop
• Solid one piece stop body for consistent contact
• Neutral appearance to suit most caravan interiors

Q: Can this Camec 75mm round door stop be used on an interior bathroom door in a caravan?

Yes, it can be used on an interior bathroom door in a caravan. The stop suits lightweight caravan-style doors that need a fixed limit to their swing. You just mount it so the door edge hits the round head before touching the wall. Make sure the surface you mount into is solid enough to hold the screw.

Q: Do I need any extra brackets or plates to install this door stop?

No, you do not need extra brackets or plates for a standard install. The kit includes the round stop and a screw intended for direct fixing. You choose a solid timber or framed spot and drill a pilot hole suited to the screw diameter. Tighten the screw until the stop sits firm and does not spin.

Q: Is this door stop suitable as a direct replacement for an older Camec 75mm stop?

Yes, it is suitable as a direct replacement where the original unit was also a Camec 75mm round stop. The overall length of 75mm and single-screw layout match the common Camec pattern. You can remove the worn stop and reuse the existing hole if it is still sound. If the old screw hole is damaged, shift the position slightly into solid material.

Q: Can I trim the 75mm length down if my door needs a shorter stop?

It is not recommended to trim the 75mm stop. Cutting the body can leave a rough face that marks the door or weakens the mounting. If you need a shorter length, it is better to select a different size of stop. Keeping the full 75mm length ensures the stop face remains square and stable against the door.

Suitable for caravan and RV door installations where a 75mm round door stop is required. Installs to a solid surface adjacent to the door using the supplied screw. Positioning depends on the swing arc of the individual door. No additional brackets or adaptors are mentioned in the supplied details.