The Camec Roller Catch-Cupboard is the bit of gear that keeps caravan cupboard doors shut when the corrugations start. The positive roller action locks onto the wire strike so the door gives a solid click as it closes. The compact housing suits overhead lockers and small pantry doors in typical caravan layouts. This catch helps stop plates and dry food sliding the door open when the van leans on uneven tracks.

The catch body uses a sturdy metal housing with a shaped roller and matching metal wire strike for long use on the road. The slotted fixing holes give you a few millimetres of adjustment so you can line it up with existing screw positions. The setup works well with standard caravan cabinetry thickness and lightweight doors used across many Aussie vans. For the price it is a smart buy when you want simple hardware that just works.

• Camec branded positive action roller catch
• Suited to caravan and RV cupboard doors
• Helps keep doors closed under road vibration
• Compact metal housing with roller mechanism
• Matching metal wire strike plate included
• Slotted mounting holes for small position adjustment
• Ideal as a replacement for worn cupboard catches
• Simple hardware piece for caravan kitchens and lockers
• Works with lightweight timber or composite cabinetry
• Handy spare part for travelling repair kits

Q: Can this catch be used on any caravan cupboard door?

It suits most light caravan cupboard and locker doors. The catch mounts to the cabinet frame and the wire strike mounts to the door, the same way as many standard caravan catches. As long as there is space for the housing and strike to meet cleanly it will work well. Always check your existing screw holes and clearances before swapping hardware.

Q: Do I need special tools to fit the Camec roller catch?

Basic hand tools are usually enough. Most installs can be handled with a screwdriver to drive the mounting screws and a tape measure or pencil to line up the catch and strike. Pre-drilling pilot holes can help in harder timbers. Taking time to align the strike gives the best positive snap when the door closes.

Q: Is this catch suitable for overhead lockers as well as lower cupboards?

Yes, it can be fitted to both overhead and lower cupboard doors. Overhead lockers benefit from a positive action catch because gear tends to push against the door under braking. Keeping the latch engaged helps avoid doors dropping open mid-trip. Just make sure the door and frame give enough room for the roller body.

Q: Should I keep a spare cupboard catch in the van?

Many caravan owners carry a spare catch or two. Cupboard hardware takes a lot of use from daily open and close cycles plus vibration from the road. Having a spare on hand means you can swap a worn or broken catch at camp. It saves running with a taped or tied door while travelling.

• Suitable for cupboard and cabinet doors in caravans and RVs where a positive action roller catch is required
• Mount catch body to the cupboard carcass and mount wire strike to the door using appropriate screws
• Can be used on lightweight timber or composite cupboard doors common in caravan interiors
• Check existing mounting hole spacing and door thickness before replacement to confirm compatibility