The Battery Link Battery Hold Down Bracket Universal keeps a single battery up to 18 cm wide clamped in its tray so it does not wander across the engine bay on corrugations. The top bar sits across the case and works with standard J bolts that hook into the battery tray on most setups. The simple layout suits starter and auxiliary batteries in utes, 4WDs and small trailers. The bracket uses a solid plastic bar instead of bare metal so you avoid corrosion when the bay cops water and dust year after year. The 18 cm internal width lines up with common battery cases so future replacements still fit under the same clamp. The smooth top surface spreads the load over the lid instead of digging into one point. That makes this a smart buy if you want basic gear that just holds the battery where it should sit.

• Universal plastic battery hold down bracket
• Suits batteries up to 18 cm (7") wide
• Helps prevent battery movement in tray
• Suitable for starter or auxiliary batteries
• Corrosion resistant plastic construction
• Works with standard battery J bolts
• Lightweight bracket for tight engine bays
• Simple, low maintenance securing method
• Ideal for vehicles, campers and trailers
• Battery Link branded electrical accessory

Q: Will this bracket fit any 12V battery?

It fits batteries up to 18 cm wide. Measure the width of your existing case before you buy to confirm clearance. If the case is 18 cm or less across the top it will sit under this clamp. Taller or shorter cases usually still work as long as your J bolts reach.

Q: Can I use this bracket in a camper trailer toolbox?

Yes, as long as the battery tray and J bolts are set up. The bracket only supplies the top clamp across the case. You still need a solid tray fixed to the toolbox floor. Make sure the J bolts are tight and the battery cannot slide front to back.

Q: Is the plastic strong enough for corrugated roads?

Yes, the plastic bar is designed to hold a single battery under normal vehicle vibration. The strength depends on correct installation and tight J bolts. Check the tension at service intervals to keep everything firm. The bracket should sit flat across the lid with no gaps.

Q: Can this be used with side post batteries?

Yes, as the clamp sits over the top of the case and does not interfere with terminals. Leave clearance around cables so the bar does not press on the leads. Side post layouts often benefit from a top clamp because the terminals sit low. Always double check that the clamp cannot touch any live metal parts.