This Battery Link adjustable hold down bracket keeps your battery from sliding around when the track gets rough. The cross bar sits over the top of cases from 14 cm to 20 cm wide so it suits a heap of common starting and auxiliary batteries. The J-bolts hook into a standard tray and the wing nuts pull it all tight so the case stays put when you tackle corrugations or rocky climbs. The bracket and J-bolts are solid metal with a protective coating that stands up to heat and grime in Aussie engine bays. The adjustable height gives you clearance over the terminals while still keeping firm pressure on the case. Flat washers spread the load so the tray does not chew out around the mounting points. For the price it is a smart buy if you want reliable, simple battery restraint that just works.

• Brand: Battery Link
• Adjustable metal battery hold down bracket
• Width range: 14 cm (5.5") to 20 cm (8")
• Height adjustment suits varied battery case heights
• Cross bar spans the battery top for stable clamping
• Pair of metal J-bolts hook into compatible trays
• Supplied wing nuts allow hand tensioning
• Flat washers help spread load on tray mounts
• Suits automotive and auxiliary batteries within width range
• Helps reduce battery movement over rough and corrugated roads

Q: Will this bracket work with a plastic battery tray?

Yes as long as the tray has lips or slots for the J-bolts and the battery width sits between 14 cm and 20 cm. Many plastic trays are moulded with hook points that suit this style of clamp. Check the tray for solid anchor points before fitting. Avoid cracked or weakened plastic around the mounting area.

Q: Can I fit this bracket to a battery on a camper trailer drawbar?

Yes if the tray accepts hook-style J-bolts and the case width is within the 14–20 cm range. Trailer setups often see strong vibration so firm clamping is important. Make sure the cross bar clears any wiring or accessories. Recheck the tension before long trips on corrugated roads.

Q: Do I need tools to adjust or remove the bracket?

No tools are required for basic adjustment because the kit uses wing nuts. You can tension or loosen the clamp by hand to swap a battery or clean terminals. A spanner can still be used on the J-bolt flats if extra clamping force is needed. Avoid over-tightening which can distort the case.

Q: How should I position the cross bar over the battery?

Place the cross bar so it sits on the solid edge of the battery case and not on raised caps or labels. This spreads the clamping load over stronger plastic. Check that it does not press on terminal posts or covers. Once aligned, tighten the wing nuts evenly until the case no longer shifts in the tray.

• Suits batteries with case width from 14 cm to 20 cm
• Fits trays that accept hook-style J-bolts at each end
• Suitable for automotive and 4WD style starting or auxiliary batteries within width range
• Install bracket over battery top then tension using supplied J-bolts and wing nuts
• Check clearance above battery terminals before final tightening