The Camec Grab Handle Gasket Vecam White steps in when the original seal on your Vecam grab handle starts to crack or flatten out. The gasket drops straight behind the handle base on setups that match Camec code 007983, giving the handle a fresh contact surface against the caravan wall. That keeps dust and splash points under control so you can get out there without worrying about a messy handle mount. This gasket uses a plastic mould with three mounting holes that line up with the standard Vecam pattern, so the handle and screws clamp everything in one go. The white finish matches most caravan door frames and cladding, so the swap looks factory once tightened. For a smart buy on small hardware, this little piece helps your existing handle kit go the distance instead of replacing the whole setup.

• Genuine Camec grab handle gasket in white
• Suits Vecam grab handle referenced as code 007983
• Designed as a direct replacement gasket only
• Plastic construction keeps weight and bulk low
• Three mounting holes match standard Vecam pattern
• Sits between handle base and caravan wall panel
• Helps tidy and seal the grab handle mounting area
• Ideal spare part for caravan and RV hardware kits
• White colour blends with common caravan door trims
• Single gasket supplied per pack

Q: Does this gasket include the grab handle itself?

No, this gasket is supplied on its own. You reuse your existing Vecam grab handle that matches code 007983. The gasket simply fits between the handle base and the caravan wall. If the handle is damaged, you will need to source the correct replacement handle separately.

Q: Can I use this gasket on any caravan grab handle?

This gasket is intended for Vecam grab handles linked to Camec code 007983. Other handle brands or shapes may have different hole spacing. For the best result, match the gasket to the handle model and check that the three mounting holes line up before installation.

Q: What tools do I need to fit the gasket?

You usually only need the same screwdriver or bit that matches your existing grab handle screws. Remove the handle, place the new gasket between the handle base and the wall, then refit the screws. Take care not to overtighten the screws so the plastic gasket can compress without deforming.

Q: Is the gasket suitable for exterior use on caravans?

Yes, this plastic gasket is suited to caravan and RV door areas where grab handles are normally mounted. The material is chosen for outdoor use around doorways and entry points. It works as a physical spacer and basic seal between the handle base and the wall. For extra weather resistance, some installers also use an appropriate sealant around the edge.

Replacement gasket suits the Camec Vecam grab handle referenced under code 007983. The gasket fits behind the grab handle base on suitable caravan or RV doors or walls where that Vecam handle is installed. Installation requires removing the existing handle from the mounting surface then placing the new gasket between the handle and the wall before refitting the fasteners. No additional brackets or adapters are listed for this gasket.