This Clipsal single power point gives you one 250V, 10A outlet with a double pole switch, handy when you want clear isolation on a caravan or RV circuit. You get standard Australian three-pin layout on a compact plate, so it drops into a normal single outlet position and handles everyday loads like chargers and small appliances without drama.

The white 15D-style plate is made from tough moulded plastic and comes with matching mounting screws, so it bolts straight onto a standard 240V back box. The contacts are rated for 250V AC at 10A, which suits typical indoor caravan power runs and cabin setups. Pair it with other Clipsal white gear and you keep the look neat while running reliable mains power through your fit-out.

• Single Clipsal power point outlet
• Double pole switching of active and neutral
• Rated 250V AC and 10A load
• Standard Australian three-pin socket layout
• White 15D-style faceplate for clean look
• Suitable for caravan and RV 240V circuits
• Supplied with matching mounting screws
• Fits standard single outlet wall boxes
• Compatible with other Clipsal white fittings
• Simple option for refits and replacements

Q: Is this power point suitable for standard 240V caravan circuits?

Yes, this power point is rated at 250V 10A which suits standard 240V caravan and RV circuits. It works with typical Australian three-pin plugs. The rating covers most small appliances such as chargers and low-power kitchen gear. Always ensure the circuit itself is wired and protected to local regulations.

Q: What does double pole mean on this Clipsal outlet?

Double pole means the switch isolates both the active and neutral conductors in one action. This can be useful where full disconnection of both lines is preferred. It is commonly used in mobile or transportable installations. The earth conductor remains connected as normal.

Q: Are mounting accessories supplied with the power point?

Yes, mounting screws are included with this power point. The screws match the plate colour and thread style for standard back boxes. This saves chasing separate hardware during an install. Check the existing wall box depth and condition before refitting any outlet.

Q: Can this outlet replace an older single Clipsal point on the wall?

In most cases yes, as it follows a standard single outlet footprint used by Clipsal. The screw spacing is designed for common Australian mounting boxes. Always confirm the existing wiring meets current standards before replacement. If uncertain, use a licensed electrician to complete the changeover.