The Clipsal Double Power Point Double Pole 25D White lets you run two 10A appliances off one standard 250V outlet, handy in a van galley or workshop bench. The horizontal twin plate keeps cords low and tidy along the wall so the setup stays clear of cupboard doors and drawers. Double pole switching gives full isolation of active and neutral on 240V circuits, which suits caravans and RVs that move between parks and generators.

The housing uses a solid white plastic faceplate matched to standard Clipsal 240V gear so it blends with other fittings across the setup. Each outlet carries a fixed 250V 10A rating, so you know exactly what the gear will handle when you plug in chargers, kettles or tools. Mounting screws are included to bolt the plate to a standard backing box, making this a smart buy when you want proven hardware on your mains run.

• Clipsal double pole double power point
• Twin standard-size horizontal mount GPO
• Rated at 250V AC and 10A
• Double pole switching isolates active and neutral
• Twin outlets on a single double plate
• White finish to match common interior fittings
• Suitable for 240V mains in caravans and RVs
• Includes matching mounting screws in pack
• Standard Australian 3‑pin outlet configuration
• Ideal for retrofits using 25D style plates

Q: Is this power point suitable for use in a caravan or RV?

Yes, this double power point suits caravan and RV installations that use 240V mains. The outlet is rated at 250V and 10A, which aligns with standard Australian caravan hookups. The double pole switching also isolates both active and neutral, which is commonly required on mobile setups. A licensed electrician should always handle the installation so the wiring matches local regulations.

Q: Does this unit replace a standard twin-size power point cut-out?

Yes, it is a twin standard size horizontal mount plate. That means it is intended to go into the same style of opening as most existing Clipsal twin outlets. The 25D form factor keeps the footprint familiar for refits and upgrades. An electrician can confirm the box size and mounting points before installation.

Q: Are the mounting screws included in the box?

Yes, matching mounting screws are included. The pack comes with screws sized to suit standard electrical mounting hardware. This saves hunting for compatible fixings during installation. The screws are designed to secure the plate firmly to the backing box so the outlets stay stable under daily use.

Q: What plug type does this power point accept?

It accepts standard Australian 3‑pin 10A plugs. The socket layout follows the common AS/NZS pattern used on most household appliances. This lets you use existing leads for kettles, chargers and other 240V equipment. The 10A rating means it matches circuits protected by typical 10A breakers or fuses.