This Sam Allen cast alloy weld-on cleat comes in at 230mm long with a 65mm overall height, so it suits typical mooring lines on small to mid-size boats along pontoons and river banks. The 125mm by 75mm base gives enough footprint for a solid weld on alloy decks, helping the gear hold bow or stern lines under steady wind and wake loads without shifting.

The cleat is marine grade cast alloy, chosen to cope with saltwater splash zones and daily UV exposure in Aussie conditions from the coast to sheltered estuaries. The 75mm width fits common rope diameters used on trailer boats around 5–7 metres. Pilot hole dimples on the underside make it easier to line up drill bits if you want extra mechanical fixing along with the weld. Paint-ready surfaces let you colour match decks after installation.

• Marine grade cast alloy construction
• Overall cleat length 230mm
• Base footprint 125mm x 75mm
• Width across cleat 75mm
• Overall height from deck 65mm
• Weld-on base for permanent mounting
• Suitable for alloy boat decks
• Pilot hole dimples on underside
• Surface can be painted after welding
• Supplied as single cleat unit (qty 1)

Q: Can this cleat be bolted as well as welded?

Yes, it can be welded and also drilled for bolts if required. The underside has pilot hole dimples that act as guides for drill bits. You can weld the base first and then add bolts for extra security. Just make sure any holes and fasteners are suitable for marine alloy and sealed against corrosion.

Q: What type of boat size does a 230mm cleat generally suit?

A 230mm cleat typically suits small to medium trailer boats and similar craft. It gives enough room for a couple of turns of standard mooring rope without crowding the horns. Many owners use this size on boats in the 5–7 metre range. Always match the number of cleats and their placement to your specific hull and docking setup.

Q: Can the alloy cleat be painted after installation?

Yes, the marine grade alloy surface can be painted after welding. Many boaties paint over the cleat so it blends with existing deck coatings. Make sure the metal is cleaned and primed with a coating suited to alloy before topcoating. Follow the paint manufacturer’s dry time and film thickness guidelines.

Q: Is this cleat suitable for saltwater environments?

Yes, it is made from marine grade cast alloy intended for saltwater use. This material is commonly used on exposed decks, jetties and pontoon setups. Basic care like rinsing with fresh water after heavy use will help it go the distance. Pair it with compatible alloy decks and fittings to avoid mixed-metal issues.

• Suitable for welding to metal boat decks or similar marine structures
• Weld-on design requires appropriate marine welding equipment and skills
• Position cleat to align with mooring line angles before welding
• Pilot hole dimples on underside assist with accurate drilling if required
• Check deck thickness and structure to support expected mooring loads
• Recommended for general mooring and docking use where a 230mm cleat is appropriate