These CAT Mudflaps Heavy Duty Size C 360mm x 230mm come as a pair so you can cover both rear wheels in one hit. The flaps throw a 360 mm high shield behind the tyres so stones and slop stay off the trailer or boat. The 230 mm width works well on trays and tubs that do not have much clearance. Bolt them on and get out there across wet back roads and job sites. Each flap runs a heavy duty flexible body sized at 360 mm by 230 mm for consistent coverage. The face shows the CAT logo so the setup looks tidy on work utes and weekend rigs. The top edge includes multiple mounting slots so you can line them up to existing brackets or new flat bar. The material handles the usual Aussie mix of bitumen heat and gravel spray without folding or cracking.
- Heavy duty CAT branded mudflaps
- Size C dimensions 360mm x 230mm
- Sold as a matched left and right pair
- Suits utes and light commercial trays
- Helps reduce mud and stone spray
- Multiple top slots for mounting options
- Flexible body to absorb debris impact
- Compact width ideal for narrow guards
- Plain rear face for tidy appearance
- Compatible with existing mudflap brackets
Q: Are these CAT mudflaps sold individually or as a set?
They are sold as a pair. You get two mudflaps in the kit so both sides of the vehicle can be covered at the same time. This suits most utes and light trucks running a single rear axle. Buying them as a pair keeps the setup matched side to side.
Q: What size vehicle suits the 360mm x 230mm mudflaps?
They suit setups that have around 360mm clearance from the mounting point to the road. Measure from the bottom of your tray or guard straight down to the ground. If that distance is close to 360mm these will usually sit at a good height. Always check local regulations for minimum mudflap coverage.
Q: Do these mudflaps come with mounting brackets or bolts?
No they come as loose flaps only. You will need existing brackets or suitable flat bar to bolt through. The flaps have top sections that can be drilled to match your hardware. This lets you line them up with different trays or bumper shapes.
Q: Can these mudflaps be trimmed to a smaller size?
Yes they can be trimmed carefully if needed. Many owners cut a few millimetres from the bottom edge to match ride height or departure angle. Use a straight edge and sharp knife for a clean line. Always trim small amounts and test fit as you go.
- Heavy duty CAT mudflap kit
- 360mm length shields trailers and tubs
- 230mm width fits narrow tray setups
- Built tough for Aussie road abuse
- Smart buy for work and weekend rigs
- Brand: Caterpillar (CAT)
- Type: Heavy duty mudflaps
- Size designation: Size C
- Height: 360 mm
- Width: 230 mm
- Quantity: Sold as a pair (2 mudflaps)
- 1 x pair of CAT heavy duty mudflaps (2 pieces)
| SKU | MDCATC |
|---|---|
| Barcode # | OEBC520838 |
| Brand | Caterpillar |
| Shipping Weight | 5.0000kg |
More infoMake 4 payments of $20.00 over 8 weeks and get it now!
Calculate Shipping
These CAT Mudflaps Heavy Duty Size C 360mm x 230mm come as a pair so you can cover both rear wheels in one hit. The flaps throw a 360 mm high shield behind the tyres so stones and slop stay off the trailer or boat. The 230 mm width works well on trays and tubs that do not have much clearance. Bolt them on and get out there across wet back roads and job sites. Each flap runs a heavy duty flexible body sized at 360 mm by 230 mm for consistent coverage. The face shows the CAT logo so the setup looks tidy on work utes and weekend rigs. The top edge includes multiple mounting slots so you can line them up to existing brackets or new flat bar. The material handles the usual Aussie mix of bitumen heat and gravel spray without folding or cracking.
- Heavy duty CAT branded mudflaps
- Size C dimensions 360mm x 230mm
- Sold as a matched left and right pair
- Suits utes and light commercial trays
- Helps reduce mud and stone spray
- Multiple top slots for mounting options
- Flexible body to absorb debris impact
- Compact width ideal for narrow guards
- Plain rear face for tidy appearance
- Compatible with existing mudflap brackets
Q: Are these CAT mudflaps sold individually or as a set?
They are sold as a pair. You get two mudflaps in the kit so both sides of the vehicle can be covered at the same time. This suits most utes and light trucks running a single rear axle. Buying them as a pair keeps the setup matched side to side.
Q: What size vehicle suits the 360mm x 230mm mudflaps?
They suit setups that have around 360mm clearance from the mounting point to the road. Measure from the bottom of your tray or guard straight down to the ground. If that distance is close to 360mm these will usually sit at a good height. Always check local regulations for minimum mudflap coverage.
Q: Do these mudflaps come with mounting brackets or bolts?
No they come as loose flaps only. You will need existing brackets or suitable flat bar to bolt through. The flaps have top sections that can be drilled to match your hardware. This lets you line them up with different trays or bumper shapes.
Q: Can these mudflaps be trimmed to a smaller size?
Yes they can be trimmed carefully if needed. Many owners cut a few millimetres from the bottom edge to match ride height or departure angle. Use a straight edge and sharp knife for a clean line. Always trim small amounts and test fit as you go.
- Heavy duty CAT mudflap kit
- 360mm length shields trailers and tubs
- 230mm width fits narrow tray setups
- Built tough for Aussie road abuse
- Smart buy for work and weekend rigs
- Brand: Caterpillar (CAT)
- Type: Heavy duty mudflaps
- Size designation: Size C
- Height: 360 mm
- Width: 230 mm
- Quantity: Sold as a pair (2 mudflaps)
- 1 x pair of CAT heavy duty mudflaps (2 pieces)
| SKU | MDCATC |
|---|---|
| Barcode # | OEBC520838 |
| Brand | Caterpillar |
| Shipping Weight | 5.0000kg |
