This Camec PVC Tow Ball Cover slips over standard 50mm and 47.63mm (1 7/8 inch) balls so you are not brushing against grease every time you walk past the hitch. The push-on design mates with the curve of the ball and stays put across rough B-road stretches and corrugations. The cover works for everyday caravan and box trailer setups that run the common 50mm tow ball profile.

The cover uses soft black PVC with a controlled wall thickness that grips the steel ball without needing clamps or screws. The material shrugs off dust, light road spray and the odd kick from a boot on a cold 5°C morning. It cleans up with a quick wipe after you top up the grease layer on the ball. For simple tow bar protection at a low cost, this cover is a smart buy for regular towing.

• Genuine Camec PVC tow ball cover
• Suits standard 50mm tow balls
• Also suits 47.63mm (1 7/8") balls
• Push-on design with moulded internal shape
• Soft PVC helps shield clothes from grease
• Helps keep tow ball protected from dust
• Simple to remove before coupling trailer
• Black finish matches most tow bar hardware
• Sold individually for single tow ball setups

Q: Will this Camec PVC Tow Ball Cover fit my standard 50mm tow ball?

Yes, it is made to suit a standard 50mm tow ball. This cover is moulded to match the curve and diameter of a 50mm ball so it slides on firmly. It also suits 47.63mm (1 7/8") balls, which are common on a lot of trailer setups. Just push it straight over the ball until it seats against the base. No tools or extra clamps are needed.

Q: Can I leave the cover on the tow ball when the trailer is not connected?

Yes, the cover is intended to stay on when you are not towing. Leaving it in place helps keep grit and dust away from the greased surface. That means less wiping and less chance of grit working into the coupling. Just pull the cover off before you lower the coupling onto the ball. Refit it once you unhitch at camp or at home.

Q: Is this tow ball cover sold as a single piece or in a pair?

It is sold individually as a single cover. If you run more than one vehicle or towbar you will need one cover for each tow ball. Buying them one by one lets you match them to the exact setups you use most. Check your tow bars for 50mm or 47.63mm markings before ordering multiples.

Q: How do I clean the PVC tow ball cover after it gets grease and dust on it?

Wipe it down with a rag and mild detergent in water. The PVC material handles common workshop cleaners in light use. A quick rinse and dry keeps the inside free of dirt that could scratch the ball. Avoid harsh solvents that might soften or mark the PVC surface. Regular cleaning helps the cover slide on and off smoothly.

• Fits standard 50mm tow balls
• Fits 47.63mm (1 7/8") tow balls
• Push the cover straight over the tow ball until fully seated
• No extra brackets or tools required for fitment
• Suitable for typical caravan and trailer tow bar setups using these ball sizes