This Ark Trailer Bearing Kit BK32 suits a single Holden pattern trailer hub and keeps the wheel turning straight when you load the drawbar for a weekend away. The small and large bearings carry hub loads so your setup can tackle highway speeds and corrugated back roads without noisy play in the wheel. The seal backs that up by keeping grease in the hub cavity where it belongs on longer drives. The steel bearings sit inside the hub with a close tolerance that works well for repeat servicing and regreasing over the life of the trailer. The dust cover fits over the hub face to keep grit and water away from the bearing races. The split pin runs through the axle nut so the adjustment you set stays put trip after trip. This kit is a smart buy when you want fresh running gear in one simple pack.

• Ark Trailer Bearing Kit BK32 for Holden pattern trailer hubs
• Kit services one trailer hub only
• Includes one small wheel bearing
• Includes one large wheel bearing
• Supplied with matching hub seal
• Dust cover included to shield grease
• Split pin included for the castle nut
• Ideal for routine trailer hub servicing
• Handy spare kit for touring trailers
• Supplied as dry components ready for greasing

Q: How many hubs does one Ark BK32 kit service?

One Ark BK32 kit services a single trailer hub. You will need two kits to replace bearings on both wheels of a standard single-axle trailer. Keeping one spare kit in the vehicle is a smart move for longer trips. That way you can sort a noisy hub on the roadside if you have basic hand tools and grease on board.

Q: Does this kit come pre-greased from the factory?

No, the bearings in this kit are supplied dry. You must pack them with a suitable high-temperature wheel bearing grease during installation. Dry bearings are standard for trailer kits so you can choose a grease that matches your existing setup. Always clean the hub and spindle before packing and fitting new bearings.

Q: Can I use this bearing kit on non-trailer machinery or equipment?

The Ark BK32 kit is intended for trailer hubs that match the Holden pattern. Some users may adapt components to other gear where the dimensions match, but that requires checking actual bearing numbers and sizes. If the hub or shaft is not built for these bearings, fitment and life can be compromised. Always confirm compatibility before swapping from the original specification.

Q: Should I replace both bearings and the seal at the same time?

Yes, it is good practice to replace both bearings and the seal together when servicing a hub. A worn seal can let grit into new bearings and shorten their life quickly. Matching fresh bearings with a new seal and dust cover keeps the hub cleaner for longer. This kit supplies all those wear parts in one go.