The Camec Access Hatch 350mm x 590mm gives you a simple way to get at service gear behind your caravan or boat wall without cutting a huge hole. The 350mm by 590mm size works well for hose runs or junctions you still need to reach later. The 525mm by 280mm opening is large enough for two hands and tools so you can tackle basic checks without stripping panels. This hatch runs a white outer frame around that 525mm by 280mm cut-out so it blends with most RV cladding. The structure sits best on vertical or sloped walls rather than flat horizontal spots where water can pool. A single integrated lock keeps casual hands off whatever you stash behind it. If you want straightforward access gear that just does the job this hatch is a smart buy.

• Camec access hatch for RV or marine applications
• Overall hatch footprint approximately 350mm x 590mm
• Internal opening dimensions 525mm x 280mm
• Suitable for vertical or sloped wall mounting
• Not intended for weather tight horizontal use
• White finish coordinates with common caravan exteriors
• Includes one integrated lock for basic security
• Service door style hatch ideal for storage or utility access
• Moulded frame and lid with rear bracing pattern
• Simple one-piece assembly ready for installation

Q: Can this Camec access hatch be mounted horizontally on a caravan roof?

No. This hatch is not intended for weather tight horizontal mounting. Horizontal roofs and decks collect standing water which can push past seals that are fine on vertical or sloped walls. For a roof opening you need a hatch that is specifically built and rated for horizontal use. Stick to wall or angled installations with this unit.

Q: What cut-out size should I allow for the Camec 350mm x 590mm access hatch?

Allow for an opening close to the stated 525mm x 280mm internal dimensions. Mark out your cut based on the frame and confirm measurements against the physical hatch before cutting. Keeping the cut-out snug helps the flange sit flat against the wall. Always dry-fit the hatch in the hole before applying any sealant.

Q: Is the hatch suitable for accessing plumbing or wiring cavities in an RV?

Yes. The hatch is suitable for RV applications where you need access to service areas. The 525mm x 280mm opening is practical for reaching plumbing joins or cable runs with tools. Fitting it to a sidewall keeps water run off under control. Seal the flange correctly so dust and spray stay on the outside.

Q: Does the hatch come with a lock included or do I need to buy one separately?

The hatch includes one lock as part of the assembly. This lock gives you basic security for storage or service spaces that do not need heavy-duty hardware. Use the supplied lock as a deterrent for casual access only. For high-value gear consider using this hatch in combination with internal barriers or additional locking points.

Suitable for RV or marine installations where a 350mm x 590mm service door is required. Hatch provides access to storage or service areas via an opening of 525mm x 280mm. Not suited to horizontal mounting where full weather tight sealing is required. Installer should frame an opening to the listed cut-out size and fasten through the perimeter flange of the hatch.