If you want a simple way to push your panels out in the sun, the Enerdrive 10 m 6 mm² Twin Solar Cable with EN4 Plugs gives you that extra reach. You get a full 10 m of twin-core cable, so you can park the van under cover and still run a folding panel out where it counts. EN4 plugs at one end tie straight into EN4-equipped solar gear without extra adaptors.

The 6 mm² conductors are sized for typical 12 V and 24 V camping solar loads over that 10 m run, keeping voltage drop in check when the panel is working hard. The sheath is solar-grade insulation, built for hot days on the roof or on the ground. Twin-core layout keeps your positive and negative together for tidy routing along drawbars, canopies or roof racks. For the price, it is a smart buy to clean up longer solar setups.

• Enerdrive 10 m twin solar extension cable
• Twin 6 mm² conductors for reduced voltage drop
• EN4 plugs pre-fitted on one end
• Suits many EN4-equipped solar panels and regulators
• Provides extra 10 m reach for campsite layouts
• Twin-core design keeps positive and negative together
• Solar-grade insulation for external cable runs
• Suitable for typical 12 V and 24 V camping systems
• Ready-made lead removes on-site crimping
• Ideal for caravans, camper trailers and canopy setups

Q: Can I cut this 10 m cable to a shorter length?

Yes, you can cut the cable shorter if needed. If you shorten the cable you will remove the factory EN4 plugs from the cut end. You will then need suitable connectors or hard wiring at that end. Shortening the run can reduce voltage drop further. Just make sure any new joins are rated for the current of your solar setup.

Q: Are EN4 plugs the same as standard solar panel connectors?

EN4 plugs match many common solar panel connectors. Most portable and fixed camping panels use this style of plug on their leads. Always check your existing panel connectors visually before ordering. Matching shapes and locking tabs are a good indicator. If your connectors differ you may need an adaptor lead between the panel and this cable.

Q: Which system voltages suit this 6 mm² twin solar cable?

This cable suits typical 12 V and 24 V solar systems. The 6 mm² conductor size is commonly used in low-voltage DC solar wiring. It supports the current drawn by many camping and touring panels over a 10 m run. Always confirm your panel current rating against your wiring and fuse selection. Oversizing cable for higher loads is good practice where possible.

Q: Can I run this cable permanently outside on a vehicle or van?

Yes, it can be used in permanent outdoor runs. The sheath is solar-suitable insulation intended for external routes. Many users run similar cable along roof racks, drawbars or caravan roofs. Protect it from sharp edges and high abrasion points. Use suitable clips or conduit where the cable passes under vehicles or around moving parts.

• Suits solar panels and regulators that use EN4 style connectors
• Extends existing solar panel cable runs by 10 m
• Suitable for 6 mm² twin solar cable terminations using EN4 plugs