This Enerdrive 10m 4mm² twin solar cable with EN4 plugs gives you extra reach between panel and battery gear so you can park in the shade and still chase full sun. With a full 10 m length and EN4 connectors matched to Enerdrive panels, it keeps your setup tidy while running standard 12 V or 24 V systems at typical current levels around 15 A from ground or roof-mounted arrays.

The twin-core layout uses 4 mm² conductors in each leg to reduce voltage drop over the full 10 m run, which matters when you are pushing every watt from portable panels. A tough outer sheath and moulded EN4 housings handle regular outdoor use in Aussie temps from roughly -20°C to 60°C. It is straightforward gear that works with existing Enerdrive solar leads, making it a smart buy for campers wanting longer cable runs without rewiring plugs.

• 10m 4mm² twin-core solar extension cable
• Factory-fitted EN4 plugs for Enerdrive panels
• Suits typical 12V and 24V solar charging setups
• Twin-core design carries positive and negative in one run
• 4mm² conductors help minimise voltage drop over 10m
• Black outer sheath for general outdoor use
• Handy length for parking in shade while panels sit in sun
• Compatible with Enerdrive solar accessories using EN4 connectors
• Simple plug-in upgrade to extend existing solar leads
• Ideal for touring, camping and off-grid power setups

Q: Can I join multiple Enerdrive 10m 4mm² twin solar cables together?

Yes, you can connect more than one as long as all connectors and cable ratings are respected. Adding extra length increases voltage drop, which lowers charge efficiency over long runs. Keep total length as short as your campsite layout allows. If you need more reach, step up panel size to help offset cable loss. Always check your regulator voltage at the battery end after changing cable length.

Q: Is this cable suitable for both fixed and portable solar setups?

Yes, it works in both scenarios when EN4 plugs are matched correctly. For portable panels, the 10m reach lets you move the panel to clear sun while the vehicle stays shaded. For fixed setups on campers or sheds, the same length helps route neatly back to a central regulator. Secure the cable to avoid abrasion and trip hazards. Routine checks on connectors will help the gear go the distance.

Q: Do I need tools to use the EN4 plugs on this lead?

No, the EN4 plugs on this cable arrive pre-fitted. You simply match the EN4 male and female ends to the compatible Enerdrive panel and lead. No crimping or stripping is needed at the cable ends. Just make sure the connectors click fully home before loading up the system. If you modify the cable, standard solar connector tools would then be required.

Q: Can this cable be left outside permanently?

The cable and connectors are suited to outdoor use but still benefit from basic care. Routing it off sharp edges and away from constant foot traffic will extend its life. If it stays out for long periods, check the sheath and EN4 housings now and then for wear. Coiling it loosely and storing it dry between trips is the best option. Avoid tight kinks which can stress the conductors over time.

• Suits Enerdrive solar panels with matching EN4 connectors
• Works as an extension lead between panel and regulator or compatible gear
• Fitment requires matching EN4 plug and socket terminations on existing setup