This Coast To Coast stone shield rubber mud flap kit steps in as backup for your trailer shield. Each flap is 500 mm wide and 350 mm high so you get solid coverage under the front guard. The pair suits trailers and caravans that already run a compatible shield frame. You just match the 500 mm width to your current setup and you are good to get out there again.

The stone shield rubber in these flaps handles flying grit from corrugated roads and loose river crossings. The 350 mm height gives you a good drop without dragging on typical towball heights. The 500 mm width lines up well with standard A frame mounting rails. The pair format keeps both sides of the drawbar covered so your kit can tackle long highway runs and the odd detour onto unsealed tracks.

• Coast To Coast brand stone shield rubber mud flaps
• Replacement pair for trailer stone shield setups
• Each flap measures 500 mm wide
• Each flap measures 350 mm high
• Supplied as a set of two matching flaps
• Intended for trailers and caravans with compatible shields
• Helps block rocks and road spray under main guard
• Plain rubber surface suitable for custom markings
• Simple rectangular profile suits many A frame shields
• Built from stone shield rubber for repeated flex

Q: Are these mud flaps sold individually or as a set?

They are sold as a pair. The kit includes two matching stone shield rubber mud flaps in one pack. That means you can replace both sides of your shield in one go. It also keeps the coverage and wear even across the front of the trailer. You do not need to chase separate left and right part numbers.

Q: What are the exact dimensions of each mud flap?

Each flap is 500 mm wide and 350 mm high. This size lines up with many trailer stone shield frames that use similar panel widths. The 500 mm width helps span the area behind the guard. The 350 mm height provides a decent drop without sitting too close to the ground. Always measure your existing setup before ordering.

Q: What type of trailers can use these mud flaps?

They suit trailers and caravans with compatible stone shield systems. The flaps are made for use behind a trailer stone shield rather than as standalone guards. As long as your shield frame takes #9 style flaps and the dimensions match, they will generally fit. Check mounting hole layout and available width on your current shield before fitting new gear.

Q: Can these mud flaps be trimmed or modified?

They can be cut, but measure carefully first. Stone shield rubber can usually be trimmed with the right tools, which helps fine-tune height or clear brackets. Any trimming should be done off the trailer on a stable surface. Once cut, the edges should be checked so they do not split under normal flex. Modifying the flaps may affect return options, so plan your cuts.

• Suits trailer stone shield systems that accept #9 style mud flaps

• Intended fitment position: front trailer stone shield area

• Suitable for use on trailers and caravans that use compatible Coast to Coast stone shields

• Check existing shield bracket width and mounting layout match 500 mm x 350 mm flap size before installation