The VES Midi Fuse Input + Busbar + three midi fuse holder lets you run three midi fuses off one solid feed, handy when you want tidy power distribution for a dual battery, canopy fit-out or camper draw system. One common input stud feeds three separate fuse spots, so you can split loads like a fridge, lights and charge circuit without stacking ring lugs all over a battery post or chassis point.

The block runs a fixed metal busbar linking the three fuse positions, with bolt-down studs sized for standard midi fuses and matching cable lugs, so the whole setup stays solid when the track gets rough. Bright top covers help you spot each fuse bank at a glance when you are chasing a fault in low light. The compact base suits mounting near batteries, DC boards or inside service spaces where every millimetre of access counts.

• VES midi fuse input block with integrated busbar
• Provides three midi fuse positions from one feed
• Suits 12V and 24V electrical distribution setups
• Compact form factor for tight mounting locations
• Shared busbar reduces need for multiple battery lugs
• Bolt-down studs accept standard ring cable lugs
• Bright orange covers improve fuse visibility and access
• Ideal for splitting loads like fridge, lights and accessories
• Helps centralise circuit protection near battery or power board
• Simple, mechanical construction for straightforward installation

Q: Can I mount this fuse holder close to the battery?

Yes, this fuse holder can be mounted close to the battery as part of a distribution point. Keeping it near the battery shortens the main feed cable, which helps limit voltage drop. A nearby mount also keeps all your main protection in one easy-to-check spot. Just allow enough space above the covers so they can open fully when you need to inspect or change a fuse.

Q: What type of fuses does this block accept?

This block is made for standard midi style bolt-down fuses. These fuses use metal blades with holes that sit over the studs on the holder. The design means you clamp the fuse between two nuts for a tight electrical joint. Midi fuses are common in 12V and 24V setups running higher current loads like fridges, inverters and charge systems.

Q: How many independent circuits can I run from this unit?

You can run three independent circuits from this unit. Each fuse position is supplied from the same input stud but protects its own downstream cable. That means a fault on one circuit will only open that fuse, leaving the other two still powered. It is a simple way to separate loads like lighting, accessories and charging from the same source.

Q: Is this suitable for both vehicle and trailer wiring?

Yes, this holder suits both vehicle and trailer wiring as long as you are using midi fuses within the correct current range for your cables. You can fit it in a 4WD engine bay, canopy, caravan front boot or camper power box. Using the same style of fuse block across tow vehicle and trailer can make spares and troubleshooting easier. Just match the fuse sizes to each circuit design.