The VES Midi Fuse Holder Red Top Single gives you a solid spot to bolt down one MIDI fuse so your main feed stays protected close to the battery. You can drop it into a dual battery board, a caravan nose cone or a ute canopy where you have about 100 mm of spare space. The bolt studs line up with standard MIDI fuse tongues so current from a fridge, inverter or charger stays in the right path.

The housing runs a tough plastic base with a bright red lid across roughly 80 mm to 100 mm of overall length, so you can see it at a glance in a busy setup. The twin mounting ears suit screws around 5 mm diameter into ply, alloy or steel. The metal studs and nuts clamp the fuse tabs over about 10 mm of thread, giving a solid connection that handles typical 12V and 24V touring loads without fuss.

• Single-position holder for standard MIDI fuses
• Red protective top cover for clear visibility
• Bolt-down studs with nuts and washers included
• Suits 12V and 24V DC automotive circuits
• Compact footprint for tight mounting locations
• Dual eyelet base for secure screw mounting
• Supports high-current main feed or accessory lines
• Ideal near batteries, fuse boards and distribution points
• Helps keep main circuit protection neat and accessible
• VES branded circuit protection accessory

Q: Can this holder be used with both 12V and 24V setups?

Yes, it can be used in 12V and 24V DC systems when paired with a correctly rated MIDI fuse. The holder itself is simply a mechanical mount for the fuse. The actual protection level comes from the fuse rating you select. Always match the fuse size to the cable and load in the circuit. A licensed auto electrician should confirm suitability for your wiring.

Q: Where should I mount this MIDI fuse holder in my vehicle?

Mount it as close to the power source as practical while still allowing safe access. Many setups place it within a short cable run from the battery or main distribution point. A solid panel, battery board, or canopy wall works well if it can take the mounting screws. Avoid spots exposed directly to moving parts, heat sources or sharp edges.

Q: Do I need any extra hardware to install the fuse in the holder?

No, the holder comes with studs and nuts for clamping the MIDI fuse tabs. You will still need suitable lugs crimped to your cables so they can slide over the studs. Use quality crimp lugs sized for both the cable and stud diameter. A proper crimping tool helps keep resistance low and joints reliable over time.

Q: Can this fuse holder be used in marine or camper trailer setups?

Yes, it can be used in marine and camper trailer electrical boards when protected from direct spray and dirt. Many people mount similar holders inside lockers, battery boxes or under-bonnet areas. Good placement and tidy cable routing help reduce corrosion and vibration issues. Regular inspection of connections is still important on boats and trailers.

• Suits standard bolt-down MIDI fuses in automotive and 4WD setups
• Fits into custom dual battery, caravan, camper trailer and marine wiring layouts
• Mount holder close to the battery or distribution point as per wiring design
• Use correctly rated MIDI fuse and cable size for the specific load
• Installation should be carried out by a suitably qualified auto electrician