The Camec Tray Rail Pillar Corner slots into caravan table or pantry setups that use 4 mm rods and tray rails. The compact corner takes the load where rails change direction and keeps movement controlled instead of sloppy across the cabinet span. Nickel plating shrugs off the usual dust and road grime you pick up on a 500 km highway run. Bolt comes separate so you can match your existing hardware stack. Camec builds this little bit of gear from metal with a nickel plated finish to keep rust at bay in coastal humidity up to around 80%. The bored holes are sized for 4 mm rods so the fit stays snug without wobble. The shape suits tight furniture cavities where clearances can drop below 30 mm. For anyone tidying worn tray rails before a 2–3 week lap, this is a smart buy that just works with standard Camec-style hardware.

• Camec tray rail pillar corner for caravan furniture
• Suits tray rail systems using 4 mm rods
• Nickel plated metal construction for durability
• Compact design for tight table and pantry cavities
• Ideal for replacing worn or damaged corner fittings
• Compatible with caravan and RV tables legs and pantry hardware
• Bolt not included, choose to match your hardware
• Helps maintain smooth movement of tray rail assemblies
• Simple component to keep existing furniture layouts working
• Suitable as a spare part in touring toolkits

Q: Does this tray rail pillar corner include the mounting bolt?

No, the mounting bolt is not included. This lets you choose a bolt length that suits your panel thickness and existing hardware. It also means you can match the head style already used in your setup. Just make sure the bolt diameter and thread suit your rail brackets.

Q: What rod size does the Camec Tray Rail Pillar Corner suit?

It suits rods with a 4 mm diameter. Using the correct rod size keeps the joint snug and reduces play in the tray rail. Undersize rods can rattle and wear faster. Oversize rods may not fit the bores or can damage the pillar during assembly.

Q: Where is this corner pillar typically used in a caravan?

It is typically used in tray rail systems on tables, legs and pantry hardware. You will usually find it at a corner or junction where rods change direction. It helps guide the rods and supports smooth movement of sliding or folding sections.

Q: Can I use this pillar corner with non-Camec tray rails?

You can use it with any tray rail system that accepts 4 mm rods and a matching bolt. Check the rod diameter and clearances in your existing hardware before buying. If the rods are 4 mm and the space matches the body size, it should function as a straightforward replacement.

• Suits tray rail setups that use 4 mm rods
• Intended for caravan and RV furniture hardware such as tables legs and pantry systems
• Requires a suitable mounting bolt to complete installation
• Check existing tray rail and rod diameter before purchase to confirm compatibility