The Lowrance TotalScan and StructureScan 3D Plastic Replacement Bracket keeps your sounder gear lined up so the beams hit straight off the hull at normal cruising speeds. This bracket is for crews already running a TotalScan or StructureScan 3D transducer and now need fresh mounting hardware after a knock or scrape. The setup gets you back to solid structure and bottom readings without paying for a whole new transducer kit.

The bracket uses a tough plastic body sized to match the standard Lowrance transom mount footprint so the screw pattern lines up with the old holes. The plastic handles constant spray and salt so it suits estuary runs, bay work and long days offshore. The mount locks the transducer at the right angle for clean returns once tightened down. For most boats it is a straight bolt-off bolt-on swap which makes this bracket a smart buy when gear gets damaged.

• Genuine Lowrance plastic replacement bracket
• Suits TotalScan and StructureScan 3D transducers
• Direct-fit footprint to existing Lowrance holes
• Designed for transom-mounted sounder setups
• Marine-grade plastic construction for saltwater use
• Helps maintain correct transducer height and angle
• Ideal when original bracket is broken or missing
• Works with stainless hardware for corrosion resistance
• Cost-effective way to restore full sonar function
• Replacement bracket only, transducer not included

Q: Does this bracket include the TotalScan or StructureScan 3D transducer?

No, this is the bracket only. This kit replaces the original plastic mount that holds your existing transducer. You keep using your current TotalScan or StructureScan 3D unit. Swapping only the bracket keeps costs down and means you do not have to rerun transducer cables. It is the right option when the mount broke but the transducer still works.

Q: Can I install this bracket in the same holes as the old Lowrance mount?

Yes, it is made as a direct replacement. The footprint and screw pattern match the standard Lowrance TotalScan and StructureScan 3D transom bracket. On most boats you remove the old mount and reuse the same hull holes. Always check the hull condition around the fixings and reseal with a suitable marine sealant to keep water out.

Q: Is this bracket suitable for use in saltwater offshore conditions?

Yes, the bracket material suits saltwater use. The body is moulded plastic which does not rust and stands up well to spray, washdowns and constant immersion. Using stainless steel screws completes a corrosion-resistant setup. Rinsing the gear with fresh water after trips will help the bracket and transducer last longer.

Q: Will this bracket work if my boat is stored on a trailer?

Yes, it works fine with trailer setups. The bracket holds the transducer close to the hull so it stays clear of most trailer rollers and skids. You still need to check clearance when winching the boat on or off. If the transducer sits near a roller, adjust the trailer or bracket height to avoid knocks during loading.

Compatible with Lowrance TotalScan and StructureScan 3D transducers for marine sounder and transducer setups. Suits transom mounting positions on suitable boats where the original Lowrance plastic bracket was supplied. Install the bracket to the hull using appropriate stainless steel fasteners and mount the matching TotalScan or StructureScan 3D transducer to the bracket body. Check mounting height and angle against the original installation instructions for the specific sounder and transducer model.