The Camec Tubular Island Leg Top Plate steps in when the original table plate on your Island tube table set code 007876 has worn out or gone missing, letting your central leg table stand solidly again on trips from the coast to the outback. The square base with four screw holes suits a typical caravan table top footprint, so you can get out there with a stable eating or card-playing surface instead of a loose wobbly setup.

The plate uses a steel base and welded tubular clamp, so the gear stays built tough when the table cops side loads, kids leaning or gear stacked up to normal caravan weights. The clamp and handle hold the matching tubular leg tight, so the table stays put as you tackle corrugated roads and sudden stops. It is a smart buy when you already run the Camec island leg kit and just need the top hardware replaced.

• Genuine Camec tubular island leg top plate
• Direct replacement for Island tube table set code 007876
• Square steel plate with four corner mounting holes
• Welded tubular clamp accepts matching island leg
• Locking handle on clamp secures table leg
• Suits free standing caravan or RV table layouts
• Mounts to underside of compatible table top
• Helps remove wobble caused by worn original plate
• Black coated finish suited to interior use
• Ideal when only the top plate needs replacement

Q: Is this top plate supplied with mounting screws?

No, this top plate is not supplied with mounting screws. You can reuse suitable existing hardware if it is still in good condition, or choose new screws matched to your table top material. For timber tops, standard countersunk wood screws in the correct length usually work well. For composite or thin tops, seek advice on suitable fixings to avoid pull-through.

Q: Can I use this top plate on a non-Camec table leg?

This top plate is intended for the Camec tubular island leg from table set code 007876. Other legs may have different tube diameters or wall thickness, so the clamp may not grip correctly. If your current leg is not from the same kit, measure the outside diameter and compare carefully. For the most reliable setup, pairing it with the matching Camec leg is recommended.

Q: Does the plate have pre-drilled holes for mounting?

Yes, the plate has four pre-drilled holes near each corner for mounting under the table top. These holes help position the plate square on the underside of the table. You can mark and pre-drill pilot holes in the top for cleaner installation. Always check for adequate edge distance so the screws have good holding strength.

Q: Is the finish suitable for use in coastal caravans?

The plate has a protective coating suited to normal interior caravan environments. In coastal regions with high salt in the air, it is good practice to keep the table area dry and wipe off spills quickly. If your van often stays near the beach, a light application of corrosion-inhibiting spray on exposed hardware can help the setup stay tidy over time.

• Suits Camec Island tube table set with reference code 007876
• Plate mounts to the underside of a compatible table top using four screws through the corner holes
• Tubular clamp accepts the matching Camec tubular island leg from the same table set
• Locking handle on the clamp secures the leg in place during use and releases it for table removal or storage