This TAG heavy duty towbar suits Mitsubishi Outlander models from 06/2021-on and gives you a solid hitch for towing the camper or box trailer. The square 50 mm receiver takes standard tongues and racks so you can swap gear between vehicles. The bar tucks under the rear bumper holding hitch height close to 450 mm to keep clearance on driveways and washouts. The bar runs across both chassis rails using thick steel around 4–6 mm to spread towing loads. High tensile bolts clamp into existing factory points at roughly 90–110 Nm so there is no guesswork. A black protective coating handles wet roads and coastal air from -10°C to 50°C. The hitch suits common 17 mm hitch pins so your current towing kit will likely drop straight in. Good, honest gear for anyone who wants a smart buy tow setup.

• Heavy duty towbar for Mitsubishi Outlander
• Suits Outlander models built from June 2021 onward
• Square hitch receiver for standard towing gear
• Steel main beam spans both chassis rails
• Black protective coating for corrosion resistance
• Mounts to existing chassis points on vehicle
• Compatible with common towballs and tongues
• Low profile design keeps good departure angle
• Suitable for towing trailers and rear carriers
• TAG branded gear from established towing manufacturer

Q: Does this towbar fit all Mitsubishi Outlander models from 2021?

It fits Mitsubishi Outlander models built from June 2021 onward. Always check your build plate to confirm the month and year before ordering. Different generations use different mounting points and bar shapes. Matching the build date helps avoid issues with bolt alignment and bumper clearances.

Q: Can I use existing bike racks with this towbar?

Yes, if your bike rack uses a standard square hitch sized to match the receiver. Many racks are built around this common hitch style. Always check the rack shank size and rating plate before use. Keep total rack and bike weight within the vehicle and rack limits.

Q: Is wiring included with the towbar kit?

No, wiring is supplied separately. Trailer wiring looms vary between vehicles and lighting requirements. Using a vehicle-specific loom helps protect the Outlander’s electronics. An auto electrician or towbar installer can recommend the right harness for your setup.

Q: Will the towbar affect rear parking sensors?

The towbar is shaped to sit under the bumper so sensors can keep working. However, some vehicles may detect the towball or any attached accessory. Many drivers switch the sensor system to tow mode when towing. Always test your sensors after installation and adjust settings if your vehicle allows.

Suitable for Mitsubishi Outlander built from June 2021 onwards.