This TAG Hitch Extender runs a 356mm pin to pin length so you can shift a bike rack clear of rear bars and spares without messing around with the towbar itself. The 50mm square shank slots straight into a matching receiver and pushes the rack back by roughly 355mm overall, handy when you are loading bikes on a wagon or ute with trays or canopies hanging out the back. The extender is built from heavy duty 50mm square steel tube with a powder-coated finish that stands up to wet roads and red dust trips across Australia. The head sits about 65mm high and the pin holes are bored to roughly 16.7mm so standard hitch pins slide straight through. The main body runs about 134mm along the inner tube with another 76mm at the tail, giving solid support for rack-only duties.

• TAG hitch extender for 50mm receivers
• 356mm length measured pin to pin
• 50mm heavy duty square hitch tube
• Overall body length approximately 355mm
• Outer head height around 65mm
• Pin hole diameter about 16.7mm
• Durable powder-coated surface finish
• Intended for carrying bike racks only
• Not rated or intended for towing
• Suits vehicles needing extra rack clearance

Q: Can this TAG hitch extender be used for towing a trailer?

No, this hitch extender is not intended for towing. It is specified for carrying a bike rack only, as noted in the product details. Towing loads would place different forces through the shank and pins. For any trailer work, you should use a rated towbar tongue. Keeping this extender for bike racks only helps protect your vehicle and hitch setup.

Q: What size hitch receiver does this extender fit?

This extender fits a 50mm square hitch receiver. Most heavy duty Australian towbars use a 50mm square socket, so it will slide straight in if your bar matches that size. The square profile keeps the rack aligned with the vehicle. Always check the inside measurement of your receiver before ordering.

Q: What diameter hitch pin does it require?

The pin holes on this extender are approximately 16.7mm in diameter. That size suits common hitch pins supplied with many 50mm towbars and racks. Using the correct pin diameter keeps movement to a minimum. Always use a steel pin and matching clip rated for towing hardware.

Q: Will this help clear a rear-mounted spare wheel when carrying bikes?

Yes, the 356mm pin to pin length moves the rack further back from the rear of the vehicle. That extra distance often helps clear rear-mounted spare wheels, canopies or trays. Measure from your existing hitch pin to the closest obstruction, then compare that to the 356mm extension. This check will confirm how much extra room you will gain.

Suitable for 50mm square hitch receivers. Extends the hitch pin location by approximately 356mm pin to pin to suit bike racks that require extra clearance from rear-mounted spares or trays. For use with bike racks only and not to be used for towing applications. Check receiver size and pin diameter of 16.7mm before installation.