The TAG Heavy Duty Towbar for Mercedes Benz Sprinter VS30 Wide Chassis gives your van a solid hitch point with a standard 50 mm receiver so you can tow trailers, pods or small plant within the factory limits. It suits wide chassis Sprinters built from 2019 onward, so if your van sits on the later VS30 platform this bar will line up with the existing mounting points without backyard drilling.

The bar runs a full width cross section in high tensile steel and uses thick plate brackets at each end to spread loading during highway or jobsite towing. A tough black powder coat layer around 80 µm thick helps resist stone strike and road grime on long runs. Bolt-on design keeps the factory chassis rails intact, which is a smart buy if you want to keep compliance and resale tidy while you get out there and work the van hard.

• Heavy duty towbar for Mercedes Benz Sprinter VS30 wide chassis vans
• Suitability for vehicles built from January 2019 onwards
• Standard 50 mm square hitch receiver for common towball mounts
• Full width steel crossbar construction for strength
• Mounting plates align with factory chassis points on wide chassis
• Black powder coated finish for corrosion and chip resistance
• Fixed rear tow point suitable for work trailers within vehicle rating
• Design keeps hitch central under rear cargo doors
• Compatible with most removable hitch tongues and pins
• Suitable for commercial, courier and trades van setups

Q: Does this towbar fit all Mercedes Benz Sprinter VS30 models?

This towbar is made for VS30 wide chassis Sprinter vans built from 01/2019 onward. It will not suit narrow chassis or earlier NCV3 models. Always check the build plate and chassis description before ordering. If you are unsure, our crew can help confirm your setup using your VIN and year.

Q: Can I use different towball mounts with the receiver?

Yes, the bar uses a standard 50 mm square hitch receiver so it accepts compatible hitch tongues rated to your vehicle’s capacity. Always match the tongue rating to the van and trailer weight. Use only pins and clips rated for towing. Regularly inspect pins and tongues for wear before long trips.

Q: Is wiring for trailer lights included with the towbar?

No, wiring looms and trailer plugs are normally supplied separately. This lets you match 7-pin or 12-pin setups to your trailer. A dedicated wiring kit can help protect the van’s electronics. Many auto electricians prefer separate loom kits for easier fault finding later.

Q: Can the towbar stay on when I am not towing?

Yes, the crossbar and receiver usually stay bolted to the van full time. The removable hitch tongue can be taken out when not towing to improve rear clearance. Leaving the main bar fitted keeps you ready to tow at short notice. It also gives some protection to the rear bodywork in low-speed bumps.

Suitable for Mercedes Benz Sprinter Van VS30 Wide Chassis from 01/2019 onwards.