The TAG Direct Fit Wiring Harness for Fiat Doblo 02/2010 on keeps your trailer lights talking to the van without cutting into random wires. The harness follows the Doblo body length at about 4.4 m so you can trace it along factory runs to the rear bar. The plug sits right where your 50 mm towball and tongue usually live so hook ups stay simple at the campsite or jobsite.

The loom uses copper conductors sized around 0.75 mm² to 1.5 mm² which is standard for 12 V lighting circuits on smaller vans. Outer sheathing adds a bit of protection from stone flick and road grime when you get out there on coarse chip or dirt. Plastic connectors match the Fiat layout so the kit behaves like factory gear on Doblos built from 2010 onward. It is a smart buy if you want tow wiring that just works.

• Direct fit towbar wiring harness
• Suits Fiat Doblo models from 02/2010-on
• Vehicle specific connector layout
• Harness length matched to Doblo body
• Multi core copper automotive cabling
• Protective outer sheathing on main loom
• Plastic connector housings for 12 V systems
• Supports standard trailer lighting circuits
• Ideal for daily work and weekend towing
• TAG branded towing electrical gear

Q: Does this harness suit all Fiat Doblo body styles from 2010 on?

It suits Fiat Doblo models built from 02/2010 onward. Body and trim levels in that build window typically share the same rear light wiring layout. Always cross check your vehicle build month and series before ordering. If in doubt our crew can help confirm compatibility against your VIN.

Q: Is this wiring harness intended for 12 volt systems only?

Yes this kit is built for standard 12 volt automotive systems. Fiat Doblo vans sold in Australia run 12 volt electrics from factory. Using the harness on higher voltage setups can damage cabling and electronics. Stick to vehicles with standard light duty 12 volt tow requirements.

Q: Can I reuse this harness on another vehicle later on?

No this harness is vehicle specific for the Fiat Doblo. The connectors and loom length are matched to that model only. Fitting it to another make or model would usually require cutting and modifying the loom. That defeats the point of a direct fit kit and is not recommended.

Q: Does the kit work with basic trailer lighting only?

The harness is intended for standard trailer lighting loads. Typical use covers brake lights indicators tail lights and number plate lamps on small box trailers and similar. Extra power hungry accessories may need separate wiring. Keep your total lighting load within normal trailer lamp current limits for best results.

Vehicle make: Fiat. Vehicle model: Doblo. Model year range: 02/2010 onwards. Harness style: direct fit vehicle specific towbar wiring harness.