The TAG D-Shackle 13mm 2000kg Drop Forged Carbon Steel slots into towbar chain lugs and recovery points that suit a 13mm body so you can hook up trailers and light loads without mucking around. The 2000kg working load limit lines up with smaller campers box trailers and runabouts where a full 3.25T shackle is overkill for the setup. Drop forged carbon steel gives this shackle consistent strength across the 13mm section so it can cop typical towing forces without drama. A galvanised finish adds a protective layer against rust which helps when you are dunking the trailer at a salty ramp or running dusty corrugations. The stamped 2000kg rating on the body keeps the rating clear at a glance which makes this a smart buy for keeping the tow rig within spec.

• TAG 13mm D-shackle for towing and recovery
• Rated working load limit of 2000kg
• Drop forged carbon steel construction
• Galvanised finish for added corrosion resistance
• Suits towbar chain lugs that accept 13mm shackles
• Compact size ideal for lighter trailers and campers
• Clearly marked with 2000kg rating on body
• Compatible with rated chains and recovery straps
• Single shackle supplied per retail pack
• TAG part number DSG013 for easy re-ordering

Q: Can this TAG 13mm 2000kg D-shackle be used for both towing and basic recovery work?

Yes, it can handle towing and light recovery within its 2000kg working load limit. This makes it handy for jobs like small trailer hook-ups and low-speed snatch or winch work where forces stay within rating. Always match it with recovery points and straps that are also correctly rated. Retire the shackle if it shows distortion, deep corrosion or thread damage.

Q: Does the galvanised finish need any special care after use near salt water?

Rinse the shackle with fresh water after salt exposure, then let it dry. This simple routine helps the galvanised coating last longer by washing away salt crystals. A quick inspection after rinsing also lets you spot any chips or wear early. Store the gear dry in a toolbox or drawer between trips.

Q: What size towbar chain lugs will generally accept this 13mm shackle?

Most lugs that take a 13mm shackle body or pin will suit this unit. Check that the eye or lug hole is slightly larger than the pin so it rotates freely without binding. The bow of the shackle should move without fouling on the towbar plate. If the fit is tight or cross-loaded, step to a different lug or hardware.

Q: How should I inspect this D-shackle before each trip?

Check the 13mm body and pin for bends, cracks or serious rust. Spin the pin through the threaded eye to make sure it turns smoothly and tightens fully by hand. Confirm the 2000kg rating mark is still visible so there is no confusion at roadside checks. Replace the shackle if anything feels rough, out-of-round or visibly damaged.