Coast to Coast Stone Shield Rubber Mud Flaps X2 #9 step in when the old flaps on your stone shield crack or tear, with each flap cut to 600 mm width and 350 mm drop for coverage. This pair suits caravan and camper stone shield setups that already use the #9 size, so you can swap them over and keep stones off the drawbar and front panels on long dirt stretches.

This kit runs simple, flat rubber at 600 mm x 350 mm per flap, so it lines up with common stone shield frames without odd shapes or brackets. The rubber handles the constant grit blast you get on corrugated roads and tracks, taking the impact instead of your paint and gear. You get two matching panels for left and right sides, a smart buy when you want the shield working again without changing the whole frame.

• Replacement rubber mud flaps for stone shields
• Suits both caravan and camper stone shield setups
• Supplied as a pair of two flaps
• Each flap measures 600 mm x 350 mm
• Compatible with #9 size stone shield frames
• Stone shield grade rubber construction
• Helps protect drawbar and front panels from stones
• Simple flat panels for straightforward installation using existing hardware
• Coast to Coast branded caravan and leisure gear
• Ideal for refreshing worn or damaged mud flaps

Q: Are these mud flaps supplied as a single piece or a pair?

They are supplied as a pair. You receive two separate rubber mud flaps sized for left and right sides of a compatible stone shield frame. This means you can refresh both sides at once and keep the shield balanced. It also saves chasing a second flap later if the other side wears out.

Q: What are the exact dimensions of each mud flap?

Each mud flap measures 600 mm x 350 mm. The 600 mm width gives good coverage across the lower edge of the stone shield. The 350 mm drop helps protect drawbar fittings and front panels from stone strike. Matching dimensions make it simple to check against your existing shield before ordering.

Q: Will these suit both caravan and camper stone shields?

Yes, they suit both caravan and camper stone shield setups that use this #9 size. The key check is that your existing frame is built for 600 mm x 350 mm rubber panels. If that measurement matches, this pair will generally bolt or clamp into place. Always confirm your frame size before replacing parts.

Q: Do these flaps include mounting hardware or brackets?

No, the kit is the pair of rubber mud flaps only. Your existing stone shield frame and hardware are used to clamp or bolt the new pieces in place. This keeps the replacement simple and focused on the wear part that normally fails. Check your current bolts or clamps and replace them separately if they are badly corroded.

These Coast to Coast stone shield rubber mud flaps suit both caravan and camper stone shield setups. They are replacement panels for compatible stone shield frames that accept 600 mm x 350 mm rubber sections. Fitment requires an existing stone shield assembly that uses this #9 size. Installation typically involves removing the old flaps and fastening the new pair to the lower edge of the stone shield using the existing mounting hardware.