This Coast to Coast stone shield rip stop mesh comes in at 1800 mm long and 500 mm high, so it lines up with common trailer stone shield frames on Aussie campers. You swap out the old torn mesh and strap this sheet across the front bar to keep stones off the van and gear. It is replacement mesh only, so you reuse the frame and hardware already bolted to the drawbar.

The rip stop fabric runs the full 1800 mm x 500 mm panel, so small cuts are less likely to spread across the shield on corrugated roads. The edge finish is built to take eyelets or lacing that match your existing setup, though this sheet comes without fittings. The simple spec keeps it a smart buy for anyone who wants their stone shield working again before the next run up a 100 km gravel stretch.

• Replacement rip stop mesh for trailer stone shields
• Supplied as mesh panel only without eyelets
• Suits existing stone shield frames on trailers
• Overall panel size 1800 mm x 500 mm
• Helps protect camper or trailer front from stone strike
• Rip stop pattern helps limit spread of small tears
• Lightweight mesh folds for compact storage as spare
• Black finish to match most drawbar shield setups
• Ideal refresh for worn or damaged factory shield mesh

Q: Does this mesh include the stone shield frame or brackets?

No, this is mesh only. The sheet is supplied as a flat rip stop panel sized to 1800 mm x 500 mm. Your existing stone shield frame and brackets stay on the trailer. You attach the new mesh to that hardware. This keeps the replacement straightforward and cost effective for worn or torn screen material.

Q: Are eyelets or mounting clips supplied with the mesh?

No, eyelets are not included. The description confirms the mesh does not come with eyelets. That means you either reuse the hardware on your old mesh or fit new eyelets yourself. This lets you match spacing to your current frame. It also keeps the part flexible across different trailer stone shield designs.

Q: Can I trim the mesh to suit a smaller stone shield?

Yes, the mesh can be cut down. The rip stop construction allows careful trimming to fit shorter or narrower frames. You may need to reseal or hem the cut edges before adding eyelets. Many trailer owners cut the 1800 mm x 500 mm sheet to tidy non standard setups. Standard cutting tools for heavy fabric are usually sufficient.

Q: Is this mesh suitable as a spare to carry on trips?

Yes, it works well as a spare panel. The folded 1800 mm x 500 mm mesh stores in a relatively small space. Many travellers keep a spare mesh in the front boot or storage box. That way a badly damaged shield can be re-skinned at camp. Carrying a spare helps keep front panels and gear protected on long outback runs.

Replacement mesh to suit trailer stone shield only. Mesh is sized at 1800 mm x 500 mm for compatible trailer stone shield frames. Eyelets are not supplied and must match the existing stone shield hardware. Fitment requires an existing stone shield frame on the trailer drawbar.