This Coast to Coast stone shield rip stop mesh comes sized at 2310 mm by 500 mm, so it lines up with standard #10 T/S caravan stone shields without trimming. It is there to take the hit from loose stones and gravel across a 2.31 m spread between the drawbar arms. Once fitted to your existing frame, it helps keep the lower 500 mm of the front wall from wearing out before its time.

The rip stop mesh pattern is laid out so any nick from a sharp chip stays local instead of running across the full 2310 mm. The panel height of 500 mm gives enough coverage for most A-frame setups while keeping weight down on the drawbar. Black mesh looks tidy against common stone shield frames and hides dust picked up over long 1000 km highway and gravel stretches. Good, straightforward kit for caravans that get out there.

• Replacement mesh for caravan stone shield
• Suits #10 T/S caravan stone shield systems
• Overall mesh dimensions 2310 mm x 500 mm
• Rip stop mesh construction helps resist tearing
• Black mesh panel to match typical shield frames
• Sized for A-frame front protection coverage
• Lightweight panel to minimise drawbar load
• Intended to reuse existing stone shield frame and hardware
• Simple swap when original mesh becomes worn or damaged
• Suitable for caravans travelling on sealed and gravel roads

Q: Is this Coast to Coast mesh supplied as a full stone shield kit or just the mesh?

This is just the replacement mesh panel. It is meant to be fitted to an existing stone shield frame that already matches the 2310 mm width and 500 mm height. You reuse your current brackets and support arms. That keeps the swap simple and cost effective when the original mesh wears out.

Q: How do I check if this 2310 x 500 mm mesh will fit my caravan stone shield?

Measure the width and height of your current mesh. If the width is around 2310 mm and the height around 500 mm, this panel should match those dimensions. Also confirm your shield is a #10 T/S style as labelled on many caravan setups. When in doubt, measure twice before ordering new gear.

Q: Can the rip stop mesh be trimmed if my frame is slightly smaller than 2310 mm?

The mesh may be trimmed by a small amount if required. Use sharp scissors or a blade and seal any cut edges as you would with fabric mesh. Always check against your frame before cutting so you only remove what you need. Careful trimming helps maintain tension and service life.

Q: Do I need special tools to fit this replacement mesh to the stone shield frame?

Most installs only need basic hand tools. Typically you undo the existing fasteners, remove the old mesh, and refit the new 2310 x 500 mm panel in the same locations. A second pair of hands can help keep the mesh tight while you refasten it. Tight, even tension across the frame will give the best result on rough roads.

• Intended as replacement mesh for caravan stone shield assemblies
• Sized to suit #10 T/S caravan stone shield setups with width around 2310 mm
• Mesh panel mounts onto existing stone shield frame using the original attachment method
• Fitment requires compatible stone shield frame already installed on the caravan A-frame
• Users should confirm current stone shield width of approximately 2310 mm before ordering
• Installation time depends on existing hardware condition and attachment style on the frame