This Coast to Coast stone shield rip stop mesh runs 2150 mm wide and 500 mm high, so it lines up with common camper drawbars without hanging low. The mesh section replaces the original screen on a #10 T/S camper stone guard when it finally tears out after too many gravel roads. You bolt or clamp this panel back onto the existing frame and get out there again without changing the rest of the setup.

The rip stop mesh grid across the full 2150 mm x 500 mm panel slows down small tears before they open up, which matters once stones start hammering in desert or outback tracks. The lightweight sheet keeps tow ball weight in check compared with steel panels of the same 2150 mm span. It is a smart buy when you want to freshen worn gear while keeping the original Coast to Coast stone shield hardware working.

• Replacement mesh for camper stone shield
• Suits Coast to Coast #10 T/S camper guard
• Rip stop mesh construction resists tearing
• Panel dimensions: 2150 mm wide x 500 mm high
• Intended for existing stone shield frames
• Helps protect camper front from stone strike
• Lightweight mesh helps manage tow ball weight
• Simple option to refresh worn stone guard mesh
• Suitable where frame accepts 2150 x 500 mm insert
• Black mesh panel as shown in images

Q: Is this mesh supplied with a frame or brackets?

No, this is a replacement mesh panel only. The panel is intended to be fitted to an existing stone shield frame on your camper. You reuse the current mounting system that is already bolted or clamped to the drawbar. This keeps the upgrade simple and reduces cost. Check that your frame accepts a panel sized 2150 mm by 500 mm before ordering.

Q: What size stone shield will this mesh suit?

This mesh suits shields that take a 2150 mm x 500 mm panel. Measure the width between the outer mounting points on your current shield and the height of the opening. If your frame is close to 2150 mm wide and 500 mm high this panel will match without trimming. Using the correct size helps the mesh stay tight and avoid flapping at highway speeds.

Q: Can I cut the mesh down to a smaller size?

The mesh can be trimmed if required. If your existing frame is narrower or lower you can cut the edges of the mesh to match. Use sharp shears and seal the cut ends as recommended by your installer to help control fraying. Always check measurements against your frame before you make any cuts.

Q: Is this mesh suitable for caravans as well as campers?

Yes, if the caravan stone shield frame matches the dimensions. The description lists this panel for a #10 T/S camper but the mesh will work on any stone guard frame that uses a 2150 mm by 500 mm insert. Just confirm the frame style and clamping method are compatible. This keeps the fit neat and helps the mesh sit tight against stone impact.