If your SOG toilet vent is already set up and the hose has had a few seasons, this SOG Connection Hose suit Type A & B 65 cm gives you a straight swap. The flexible hose links the cassette outlet to the vent housing over a fixed 65 cm run, so airflow stays consistent. It suits SOG Type A and Type B kits on side, roof or floor vents where that original hose length is required.

The ribbed hose material lets you snake it around cupboards and framing without sharp kinks across the 65 cm length. The moulded connection piece matches SOG Type A and Type B fittings, so the joint seats cleanly on the existing plastic hardware. For anyone keeping a SOG ventilation system working in Aussie touring conditions, this is a smart buy to refresh an ageing hose without reworking the whole setup.

• Genuine SOG replacement connection hose
• Suits SOG Type A ventilation systems
• Suits SOG Type B ventilation systems
• Hose length set at 65 cm
• Flexible ribbed hose for tight routing
• Includes dedicated SOG connection piece
• Compatible with side vent SOG layouts
• Compatible with roof vent SOG layouts
• Compatible with floor vent SOG layouts
• Ideal for caravans and motorhomes using SOG toilets

Q: Does this hose include the plastic connection piece?

Yes, the hose is supplied with a matching connection piece. This means you receive the flexible hose and the end fitting in one kit, ready to fit to compatible SOG hardware. You do not need to reuse an old connection piece if it is worn. This keeps the joint between hose and SOG unit consistent with the original setup.

Q: Will this hose fit any SOG toilet ventilation system?

No, it is made for SOG Type A and Type B units. Other SOG types use different hose and fitting arrangements, so they may not match this connection piece or the 65 cm length. Always check the label or paperwork on your existing SOG kit. Matching the type code avoids poor sealing or incorrect hose routing.

Q: Can this hose be used on side, roof and floor vent layouts?

Yes, it suits side, roof and floor venting SOG Type A and Type B setups. The flexible construction lets you route the 65 cm run to existing wall, roof or floor outlets. The key point is that the base unit is a Type A or Type B SOG system. If that matches, the hose will suit the vent direction used by that kit.

Q: Is the hose length adjustable if my run is shorter than 65 cm?

The hose is supplied at a fixed 65 cm length. It is intended as a direct replacement for the original hose on many SOG Type A and Type B installations. If your existing run is shorter, your installer may cut the hose to suit during fitting. Any trimming should preserve a clean end and a secure joint on the connection piece.

This connection hose suits SOG Type A and Type B toilet ventilation units only. The hose fits side venting SOG setups. The hose fits roof venting SOG setups. The hose fits floor venting SOG setups. Confirm your existing kit is a SOG Type A or Type B system before purchase. Follow the original SOG installation instructions when replacing the hose.