The Camec Single Cold Tap slots neatly into small caravan and RV sinks with a fixed pillar height of 66 mm and a spout reach of 110 mm, so you keep good hand room without wasting bench space. The 1/2" male BSP thread lines up with common van plumbing, making it a smart buy when you want to swap out a worn tap and get out there again without reworking the whole setup. The metal body with chrome finish is built tough for constant on off use in Aussie conditions from the bush to the beach. A 45 mm base footprint spreads the load on light stainless or plastic sink tops, while the 46 mm under-bench thread gives plenty of bite for the mounting nut. The 24 mm outlet drop helps tame splash in shallow bowls, so the kit stays practical for everyday touring jobs.

• Single cold fixed pillar tap design
• Suits caravan and RV sink installations
• Low profile height of 66 mm above bench
• Spout reach of 110 mm for compact bowls
• Outlet drop of 24 mm to control splash
• 1/2" male BSP threaded connection
• Base diameter of 45 mm spreads load
• Under-bench thread length of 46 mm
• Stainless steel body with chrome on metal finish
• Simple single-handle operation for cold water only

Q: Is this tap suitable for hot water lines?

No, this tap is supplied as a single cold tap only. It is intended for cold water feeds from a mains hookup or 12V pump system. If you need hot and cold control, you will need a mixer tap instead. Running hot water through a tap not rated for it can shorten seal life and cause leaks over time.

Q: What size hole do I need in the sink or benchtop?

The tap mounts through a hole that suits a 1/2" BSP male thread with a base diameter of 45 mm. Most caravan and RV sinks already have a compatible opening for this style of tap. If you are drilling a new hole, match the thread clearance and allow flat support around the 45 mm base.

Q: Can this tap be used with plastic caravan sinks?

Yes, the 45 mm base spreads the load so it can be mounted to typical plastic or stainless caravan sinks. Make sure the mounting surface is flat and use the supplied nut and any backing washer to support the plastic. Do not overtighten the nut, as too much force can distort lighter sink materials.

Q: Does the tap include an aerator at the outlet?

Yes, the outlet features a small aerator insert at the tip of the spout. This helps shape the water stream from the 24 mm drop, which can reduce splash in shallow bowls. The aerator also gives a more controlled flow when using low pressure pump systems common in caravans and camper trailers.

• Suitable for caravan and RV sinks using 1/2" male BSP connections
• Requires compatible 1/2" BSP female plumbing fitting for installation
• Fixed height pillar design suits benchtop or sink mounting with 45 mm base clearance
• Single cold line connection only; not a mixer tap