This Coast to Coast S/S Flexible Hose at 600 mm gives you a straightforward link from a single LPG bottle to your regulator using a POL end and 1/4" NPTM outlet. The stainless braid across the full 600 mm length handles tight runs in caravan lockers and drawbars. The hand wheel on the POL side means you can clamp or release the bottle connection by hand while keeping the hose path fixed.

The hose runs stainless steel braid over the gas line for consistent protection across every 600 mm. Brass POL and 1/4" NPTM fittings match common LPG bottle valves and regulator ports used around Australia, so it drops into standard single-cylinder setups as a smart buy. The compact length suits fixed regulators mounted close to the bottle, cutting down spare hose loops that can snag or kink in small storage spaces.

• Stainless steel flexible gas hose construction

• Suits single bottle LPG gas kits

• Overall hose length approximately 600 mm

• POL connection at cylinder end

• 1/4" NPTM thread at regulator end

• Integrated hand wheel at POL fitting

• Ideal for caravan and RV gas lockers

• Pigtail style hose keeps runs compact

• Suitable for compatible LPG systems using POL and 1/4" NPT

Q: Can this hose be used with any LPG bottle in Australia?

It suits LPG bottles that have a POL valve. The hose end uses a standard POL connection commonly found on Australian refillable cylinders. If your bottle has a different valve style it will not mate with this hose. Always match the POL fitting and seal face before connecting your gas setup.

Q: What thread is on the regulator end of the hose?

The regulator end has a 1/4" NPTM thread. This suits regulators or fittings with a matching 1/4" NPT female port. If your regulator uses a different thread type you will need an appropriate adaptor. Do not force mismatched threads as this can damage the gear and compromise the gas seal.

Q: Is the 600 mm length measured including the fittings?

The listed 600 mm length refers to the overall hose assembly. That means the measurement runs from end fitting to end fitting along the hose. This helps you judge the run from bottle outlet to regulator inlet. Always allow a little slack so the hose is not stretched or kinked when installed.

Q: Can this hose be used on a dual bottle changeover setup?

This hose is described for single bottle kits. A dual bottle changeover system usually uses matched pigtails from each bottle into a changeover regulator. If you are planning a dual setup your gear should use hoses of the same length and type. Check your regulator specifications and local gas rules before selecting hoses.

• Suits single bottle gas kit configurations

• Connection one: POL adapter to LPG gas bottle

• Connection two: 1/4" NPTM thread to compatible regulator or appliance

• Hose length 600 mm supports compact cylinder placements in caravans and RV setups

• Installation requires matching 1/4" NPTF female port or adaptor on downstream gear

• Use only with LPG systems and components rated for POL and 1/4" NPT interfaces