This Roadvision licence plate LED light runs on a 10-30V DC range, so it slots straight onto 12V or 24V setups without extra gear. The 4 LED array throws an even spread across plates roughly 370 mm wide on utes, box trailers and caravans. The surface-mount body keeps height under about 50 mm, handy when you are backing up close to posts or rocks.

The housing uses a black plastic body around 3 mm thick with a clear lens about 30 mm wide, so it cops the usual dust and road spray without drama. Power draw stays well under a standard 5 W globe, a smart buy if you are already running extra 12V gear off the same loom. The light comes blister packed so you can throw it straight into the spares box in the shed or canopy.

• Roadvision licence plate LED light for rear number plates
• Suits 10-30V DC electrical systems
• Compatible with both 12V and 24V vehicles
• Fitted with four individual LED emitters
• Surface mount style for simple panel installation
• Black body housing with clear lens
• Low power LED technology reduces current draw
• Supplied blister packed for retail or workshop storage
• Ideal for utes, trailers, caravans and light trucks
• Helps keep plate area clearly illuminated at night

Q: Will this Roadvision licence plate light run on both 12V and 24V vehicles?

Yes, it operates on 10-30V DC, so it suits both 12V and 24V systems. That means you can use the same light across utes, trucks and trailers without separate part numbers. It helps when you are standardising gear in a small fleet. Just match the wiring polarity and mount it where it clears the plate.

Q: Is the light suitable for surface mounting on trailers and caravans?

Yes, the unit is specified as a surface mount licence plate light. You bolt it straight onto a flat panel or bracket without cutting a large hole. That keeps install time down and works well on thin trailer sheet. Just make sure the mounting surface is solid enough for two fixing points.

Q: How many LEDs are inside this licence plate light?

This Roadvision lamp uses four individual LEDs. The four-point layout spreads light across the plate instead of one bright hotspot. That makes characters easier to read from different angles. It also means if one LED fails the others still provide usable light.

Q: What colour is the body of the light?

The housing is a black body with a clear lens. The black finish helps it blend into most rear bars, trays and bumpers. It looks tidy on darker paint or powder-coated steel. The clear lens lets the white LED output reach the full plate width.