Tycab Red 00 B&S Single Core cable steps in when your 12V setup needs proper current carry for winches or big inverters over runs of around 3 to 5 metres. Each metre handles up to 370 Amp in typical dual battery or canopy builds, so you can tackle long touring days without stressing about voltage drop to key gear. The conductor packs 798 copper strands at 0.32 mm so the cable bends cleanly through tight chassis gaps and drawer systems. The red insulation is heat rated to 90 Deg which suits hot engine bays and Ute tubs in Australian summers. The size lines up with common 00 B&S lugs and hardware, making it a smart buy when you are standardising cabling through the whole rig.

• Tycab 00 B&S red single core automotive cable
• Sold per metre for custom length runs
• Current rating of 370 Amp for high draw circuits
• Heat rated insulation to 90 Deg for engine bay use
• Flexible construction with 798 copper strands
• Strand diameter of 0.32 mm for easy routing
• Suitable for 12V and 24V DC systems
• Ideal for winch feeds and inverter supply cabling
• Matches common 00 B&S crimp lugs and connectors
• Suits dual battery links in 4WDs and caravans

Q: Is this Tycab 00 B&S cable sold as a continuous length?

Yes, this cable is sold per metre as a continuous length where possible. If you order 5 metres you receive one 5 metre piece, not five 1 metre pieces. This makes routing along chassis rails and around tubs much tidier. You can then cut it to suit your dual battery, winch, or inverter layout.

Q: Can this cable be used in both 12V and 24V systems?

Yes, this 00 B&S single core suits both 12V and 24V DC systems. The key factor is the current draw in amps rather than the nominal voltage. With a 370 Amp rating it covers most large 4WD and caravan circuits. Always match the fuse or breaker rating to protect the cable in your particular setup.

Q: What size lugs or terminals match 00 B&S cable?

You will need lugs specifically marked as 00 B&S or equivalent size. These lugs are bored to suit the heavy cross section of this cable. Using the right lug size gives a snug fit on the copper strands. This helps achieve a solid crimp and keeps resistance and heat build up under control.

Q: Is the red insulation suitable for exposed exterior runs under a vehicle?

The red insulation is rated to 90 Deg and offers good abrasion resistance for automotive use. Many people run this cable along chassis rails or in protective conduit under the vehicle. Securing it with proper clips and adding split tubing where it might rub gives the best long term result. Regular checks during servicing will keep on top of any wear.