The Coast to Coast pole carrier end pin assembly at 100mm gives your 200cm x 10cm storage tube a solid closure so poles stay where they should. The pin length matches the 10cm diameter tube so you get clean retention without overhang catching on gear. The setup suits annex poles or similar hardware that lives in a front drawbar tube on caravans and campers. The metal construction ties straight into the 100mm tube mouth for a square seating surface that handles knocks and vibration on corrugated roads. The round head caps the 10cm opening while the integrated ring makes the pin simple to pull when you roll into camp. The sizes line up with common Coast to Coast 2000mm x 100mm pole carriers so you can swap this straight in as replacement kit and get out there again.

• Genuine Coast to Coast pole carrier end pin assembly
• Suits 200cm length x 10cm (100mm) diameter pole carriers
• 100mm pin length sized for 10cm tube
• Helps retain annex poles and similar gear inside storage tube
• Metal construction suited to caravan and RV use
• Round head covers 100mm tube opening for secure closure
• Integrated ring allows straightforward removal and refitting
• Ideal replacement part for worn or lost pole carrier pins
• Compatible with Coast to Coast storage tube style pole carriers
• Compact design keeps carrier end neat on drawbar or rear bar

Q: Will this end pin assembly fit any pole carrier?

It fits pole carriers that are 200cm long with a 10cm (100mm) diameter. The pin and head are sized specifically around that 100mm tube opening. If your storage tube has a different diameter this pin may not seat properly. Check the length and diameter of your existing carrier before ordering to make sure the sizes line up.

Q: Is this sold as a complete assembly or just the pin?

This is sold as a single pole carrier end pin assembly. The assembly includes the pin body and the ring that locks it in place. It is intended as a replacement for the matching Coast to Coast 200cm x 10cm pole carrier. You only receive one assembled pin unit in the pack.

Q: Can I use this end pin on a homemade PVC storage tube?

You can use it if your tube matches the 10cm diameter. The head needs that 100mm face to sit against so a smaller or larger pipe will not seat correctly. Many DIY tubes use different pipe sizes so measure the outside and inside diameters first. Matching those sizes will help the gear work as intended.

Q: Is any drilling or modification needed to fit this to the matching Coast to Coast carrier?

It is made to suit the existing end arrangement on the Coast to Coast 200cm x 10cm carrier. The factory tube already has the required end layout for the pin to pass through. You simply align the assembly with the end opening and slide it into place. No additional brackets or extra hardware are listed for this setup.

• Suits Coast to Coast pole carrier with length 200cm and diameter 10cm (100mm)
• Fits storage tube style pole carrier on caravans and RVs
• Installs at the end of the 10cm diameter pole carrier as the retaining pin
• Intended for securing poles or similar gear inside the matching 200cm x 10cm carrier