This Coast to Coast pole carrier end cap suits a single storage tube that is 2000mm long and 150mm in diameter, so it is a smart buy when you want poles to stay put on the drawbar. The cap closes off a 150mm PVC tube and helps keep annex poles and similar gear from creeping out over corrugations or braking. You can run the usual highway and backroad stretches without poles rattling straight out of the carrier. This bit of gear uses PVC that matches common 150mm pipe fittings built to AS/NZS 1260, so it lines up with standard storage tube setups on most caravans and RVs. The 150mm face gives full edge coverage, spreading any knocks from loose poles across the cap instead of one small point. The setup suits Aussie conditions where dust, rain and constant vibration will quickly show up weak fittings, so this is solid gear for regular touring.

• Suits Coast to Coast single pole carrier
• Compatible with 2000mm x 150mm storage tube
• 150mm nominal diameter end cap
• Manufactured from PVC material
• Matches common 150mm PVC pipe fittings
• Marked to AS/NZS 1260 standard
• Helps contain poles during caravan travel
• Ideal replacement for damaged end caps
• Suitable for caravan and RV storage setups
• Simple component for 150mm pole carrier systems

Q: Does this end cap fit any pole carrier size?

No, this end cap suits a single pole carrier that is 2000mm long and 150mm in diameter. The cap is intended for carriers built around 150mm PVC tube, so using it on smaller or larger diameters will not give a secure fit. Always confirm your storage tube is 150mm before ordering. Mixing sizes can lead to loose caps and lost gear.

Q: Is this sold as a full pole carrier kit?

No, this listing is for the 150mm end cap only. The main 2000mm x 150mm storage tube and mounting brackets are separate components. This makes it useful as a replacement part when the original cap is damaged or misplaced. Check your existing carrier style so you only buy the pieces you actually need.

Q: What material is the end cap made from?

The end cap is made from PVC. This matches common 150mm pipe fittings used on caravan storage tubes, so you get consistent material where the cap meets the carrier. PVC handles regular outdoor use on touring rigs. It also keeps weight down on the drawbar or rear bar where every kilogram matters.

Q: Where is this end cap typically used on a setup?

The cap usually sits on the open end of a 150mm PVC pole carrier mounted to a caravan or RV. Many setups run the 2000mm x 150mm tube along the drawbar or across the rear bar. The cap helps keep awning poles and annex frames contained during travel. It also helps shield the tube opening from direct dust entry on unsealed roads.

• Suits Coast to Coast single pole carrier with length 2000mm and diameter 150mm
• For use on storage tube style pole carriers on caravans and RVs
• Compatible with 150mm PVC storage tube systems marked AS/NZS 1260