The Oztent Foxwing Tent Pole 2.2m Bent Spigot steps in when a leg gets bent or lost and you still want that 2.2 m awning height along the side of the wagon. The bent spigot locks into the Foxwing hardware so the canvas stays at its intended 2.2 m reach without mucking about. One pole sorts a standard Foxwing wing, giving that familiar coverage out to about 2.2 m from the vehicle.

The tube length sits at 2.2 m which lines up with normal Foxwing setups on lifted 4WDs and standard-height vans. The bent spigot matches the factory Foxwing fittings so your existing ropes and pegs stay in the same 2.2 m layout. You get straightforward swap-over gear that keeps the awning frame square and the load spread cleanly along that 2.2 m edge.

• Genuine Oztent Foxwing replacement tent pole
• Overall pole length approximately 2.2 m
• Bent spigot top to suit Foxwing awning
• Intended for Foxwing awning leg support
• Helps restore original awning height and tension
• Useful spare leg in touring or camping kit
• Simple swap-in part with no extra brackets
• Suits camping setups beside 4WDs and vans
• Classified as a tent and awning accessory pole

Q: Is this pole only for the Oztent Foxwing awning?

Yes, this tent pole is intended as a replacement for the Oztent Foxwing awning system that uses a bent spigot top. The bent spigot matches the Foxwing hardware on the awning ends. Using it with other awnings may not line up with their eyelets. For best results keep it with a Foxwing setup.

Q: What is the full length of this replacement pole?

The pole is specified at 2.2 metres overall length. This suits the standard Foxwing awning height along the vehicle side. It keeps the canvas tension similar to the original legs. That way your existing ropes and pegs still line up close to where you expect.

Q: Can I carry this as a spare pole in my camping kit?

Yes, this pole works well as a spare leg for a Foxwing awning. Keeping one in the camping kit means a bent or lost leg will not end a trip. The 2.2 metre length matches the factory legs so it drops straight into the setup. Many touring crews carry at least one spare pole.

Q: Does the bent spigot come already attached to the pole?

Yes, the bent spigot is part of the pole assembly. There is no need to fit extra hardware before use. You simply place the spigot through the Foxwing eyelet and then tension the awning with ropes and pegs. This keeps setup time similar to your original legs.

Suitable as a replacement tent pole for the Oztent Foxwing awning setup.